2. Rugged Ridge
  3. Cloth Seat Protectors

Rugged Ridge Cloth Seat Protectors Installation guide

  • Hello! I'm your chat assistant. I've reviewed the installation instructions for the Rugged Ridge 1976-2006 Jeep Neoprene Front Seat Vests. This document details the step-by-step process of correctly fitting the seat protectors using bungee cords and hooks. I'm here to answer any questions you have about the installation process or the product itself.
  • What parts are included?
    Where are the hooks for the bungee cords found?
    Where should the bungee cord hooks be attached?
Page
1
Installation instructions ( p/n: 13235.19)
1976-2006 Jeep® Neoprene Front Seat Vest/Protectors
Parts included: (1) Front driver's side seat vest
(1) Front passenger's side seat vest
Instructions:
Step(1)
Step (2a)
Step (2b)
Step (3a)
Step (3b)
Step (4a)
Step (1) Slide upper
portion of seat protector
onto top of seat and
loosely lay seat protector
over seat.
Step (2) Run flap on back
side of protector between
the upper and lower
portion of seat.
Step (3) Attach supplied
hooks (found in the mesh
pouch on the back of the
vest) to all 8 bungee cords
as shown.
Step (4) Attach the hooks
on the bungee cords
underneath the seat where
they will be secure and
supported (Do not
overstretch bungee cords).
Take care to not run the
cords where there may be
interference with the slider
or the fold forward seat
riser.
Step (5) Inspect that your
seat vest is secured well
and that no cords are
under or over tight.
Step (4b)
Step (3b)
/