BLOTZ B10-ME-202 Assembly Instructions

Hello! I've reviewed the instructions for the BLOTZ City Wall B10-ME-202. This document provides a comprehensive guide on how to assemble the model, including attaching the rear wall, base, walkway and front wall pieces. I'm ready to answer any questions you may have about the assembly process or the model itself.
What kind of glue is required?

What tools are needed for assembly?

What should I do before starting construction?

10mm Ancient City Wall - Short

B10-ME-202

Please read these instructions fully before starting construction.

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and

remember to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place

while you allow glue to dry.

Take the pieces shown above from the sprue.

Glue them together as shown.

Attach them to the back of the rear wall section.

Glue the sub-assembly to the base.

Add the walkway.

The front wall pieces and strip.

Glue the front wall pieces to the model.

Then add the decorative strip.

The completed building.