2. BLOTZ
  3. B20-ME-101

BLOTZ B20-ME-101, B20-ME-103, B20_ME_101, B20_ME_103, BH0-ME-101, BH0-ME-103 Assembly Instructions

  • Hello! I've reviewed the instructions for assembling the BLOTZ Desert Fort B20-ME-101. This document guides you through the process using wooden components and provides steps for construction, recommending tools like a modelling knife and PVA glue. I'm ready to answer your questions about putting together this Corner Wall model.
  • What type of glue is needed?
    What tools are needed for assembly?
    What can be used to hold pieces while the glue dries?
20mm Desert Fort – Corner Wall
B20-ME-101
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Turn the “roof” upside down and attach the other
pieces to it as shown.
Take the two front wall sections.
Attach these to the model.
Turn the model the right way up and attack the
base, slotting each lug into the associated hole.
The finished model.
/