MooreCo Ganging Device Assembly Instructions

Hello! I've reviewed the assembly instructions for the Ganger 66640 which shows how to connect tables using either pre-drilled holes or threaded inserts. The document includes parts list and hardware list so if you have any questions about the instructions or compatibility of components, please feel free to ask.
How many Gangers are included?

What type of screws should be used with predrilled tables?

What type of screws should be used with tables with threaded inserts?

#66640 Ganger

ABall-Head Wood Screw 4 EA

BBall-Head Machine Screw- 6mm 4 EA

C Ball-Head Machine Screw-1/4”-20 4 EA

Part Drawing Description Qty

Hardware List

Parts List

P-1 Ganger-Rubber 2 EA

For Tables with Predrilled Tops:

For Tables with Treaded Inserts:

1. Pick the side of the Tables you want to

gang.

2. Determine thread size of your threaded inserts.

3. Screw in two Ball-Head Machine Screws (B or C)

into the embedded treaded inserts in the bottom

of your Tables. See illustration #2.

4. Snap and Stretch the Ganger in place over

the Ball-Head Screws.

1. Pick the side of the Tables you want to

gang.

2. Screw in two Ball-Head Wood Screws (A)

into the predrilled holes in the bottom of

your Tables. See illustration #1.

3. Snap and Stretch the Ganger in place over

the Ball-Head Screws.

illustration #1

illustration #2

66640_7-2-14

A

P-1 Predrilled Hole

Threaded Insert

B or

C

P-1

Part Drawing Description Qty

/

Other documents