Crown Automotive J8126659 Installation guide

Hello! I have reviewed the installation instructions for the Crown CJ Voltmeter J8126659. The document provides step-by-step instructions on how to properly install your new device, including important wiring information. I'm ready to answer any questions you have about installing this voltmeter. Please feel free to ask anything.
What should I do before removing any electronics?

What should I do with the wires before removing the original voltmeter?

What color wire is for the power terminal?

What color wire is for the ground terminal?

What color wire is for the illumination power?

Crown Automotive Sales Co., Inc.

CJ Voltmeter

Installation Instructions

Replaces Part #: J8126659

1. Before any electronics are removed, disconnect the battery.

2. Label wires prior to removal to aid in proper re-installation

3. Remove original voltmeter, clean mounting surface and install new voltmeter. Slide mounting bracket onto the back of

the gauge and install using the supplied hardware. Do not over-torque hardware as it

may damage the gauge.

Proper wiring is as follows:

• + Terminal – Power (Yellow)

• – Terminal – Ground (Black)

• Spade Terminals – Illumination Power (Orange) & Ground (requires a separate ground)

4. Re-connect battery after gauge is installed and all wiring is connected to the gauge. Ensure all components are

functioning properly.

Improperly wiring these gauges will result in gauge failure and will void the warranty.



Whileeveryattemptismadetoensurethattheinformationcontainedintheseinstructionsiscorrect,noliabilitycanbeacceptedbytheauthorsforloss,damage,orinjury

causedbyanyerrorsin,oromissionsfromtheinformationgiven.Allserviceshouldbeperformedbyqualifiedmechanics.CrownAutomotiveSalesCo.,Inc.cannotbeheld

responsibleforanymechanicalworkperformed.Standardandacceptedsafetyprecautionsshouldbeusedineveryprocedure.

Crown Automotive J8126659 Installation guide

Other documents