Steba IK 650 SLIM Owner's manual

www.steba.com

220 - 240V; 3400Watt; 50/60Hz

Induktion

IK 650 Slim

Gebrauchsanweisung 2

Instructions for use 9

Mode d´emploi 15

Gebruiksaanwijzing 21

Brugsanvisning 28

Page is loading ...

9

Cookware

∙ Applicable are enameled or induction-appropriate pots. Minimum diameter

12 cm, but not larger than the ring on the glass plate. Too large pots can lead to an

overheat of the electronic. You can test with a magnet whether your cookware is

suitable or not.

If it sticks to the base of the pot, you can use the pot.

∙ Pots made of aluminum, copper, glass, ceramics and chrome nickel steel are not

suitable.

∙ Make sure that the bottom of the pot is flat and not too thin, as this will influence

the temperature regulation negatively.

∙ Caused in the composition of the materials of the pot, some noise might be heard

during cooking.

∙ Place the appropriate pot / pan (minimum diameter 12 cm) in the middle of the

plate.

Generally

This appliance is only for private use, in small shops, offices, mo-

tels and indoor use and must not be used commercially. Please

read the instruction manual carefully and keep it at a safe place.

When the appliance is given to another person the instruction

manual should be passed to that person, too. Only use the ap-

pliance as described in the instruction manual and pay attention

to the safety information. No liability for damages or accidents

will be accepted, which are caused by not paying attention to the

instruction manual.

Safety information

∙ Persons with heart pacemakers should consult their doctor be-

fore using the device.

∙ Ensure that the power supply is adequately protected.

∙ Before using the device check whether the glass surface or the

power cord is damaged. In this case do not use the appliance!

∙ The appliance can be used by children aged 8 and above

and persons with limited physical, sensory or mental capa-

bilities or lack of experience/knowledge, provided that are su-

pervised or have been provided with instruction in the safe use

of the appliance and have understood the resulting dangers.

Children must not use the packaging as a plaything. Cleaning

10

and user maintenance must not be carried out by children un-

less they are 8 years or older and are supervised.

∙ Children under the age of 8 must be kept away from the appli-

ance and the connecting cable.

∙ The appliance must not be operated using a timer or a separate

remote system!

∙ Only plug in the device as described on the rating label.

∙ Place the device on a stable, flat, temperature resistant and

nonmetallic surface. Do not touch the top plate shortly after re-

moving the pot or the pan, as the top plate will still be very hot.

∙ Do not block air intake or exhaust vent.

∙ Never immerse the appliance or the power cord into water or

other liquids (risk of electronic shock). Protect the device from

moisture!

∙ To prevent injury, repairs such as replacing a damaged cord,

should only be carried out by a customer service.

∙ If an extension cord is necessary, pay attention that it is suitable

for the device. If a cable drum is used, always unwind it.

∙ Do not plug with wet hands.

∙ Always pull the plug, not the cord.

∙ Pay attention that the power cord does not get in touch with

hot parts.

∙ Do not put any pointed objects into the air intake. Risk of elec-

tronic shock!)

∙ Never place empty pots, cutlery or other metallic objects onto

the device. Those objects will get hot! Do not heat cans, they

can explode. Do not place a sheet of paper between the pot or

the pan and the unit. The paper may get burnt.

∙

In order to protect the electronic parts, the ventilation

runs for a couple of minutes after the device has been

turned off.

11

∙ The glass surface can have a residual heat after cooking.

.

∙ Attention! Do not place hot pots or pans onto the con-

trol panel! Not warranty payments!

∙ Do not carry the unit when the pot or the pan is on it.

∙ Do not use the device if unsupervised. Oil and fat can

catch fire if they get too hot.

∙ Do not place near objects which are affected by magnet. (e.g.

automatic-banking cards).

∙ Unplug the device after every use (not if built-in!)

∙ Attention!

Device gets hot!

Risk of burns!

∙ While using the device, the surface can get very hot. Don´t

place the device on a sensitive surface (c.g. painted furniture)

and keep distance of at least 70 cm to burnable materials (e.g.

curtains).

Cleaning

∙ Clean after every use

∙ Unplug the device and wait until cooled down.

∙

Never immerse the device into water and never run water

over the unit. Pay attention that no liquids can get into

the device through the air inlets.

∙ A discoloration or storing can be caused if pots are used which

are not clean at the bottom.

∙ Use a damp cloth and some detergent for cleaning.

∙ Do not use any abrasive milk, polishing wool or solvent for clea-

ning.

∙ Use vacuum cleaner to suck up dirt from the air intake and ex-

haust vent.

12

How to use the device

∙ Plug the device into an earthed socket.

∙ A signal tone sounds, the display is illuminated. The device is in stand-by mode.

∙ Place the induction suited cookware with a min. diameter of 12cm on the plate.

∙ Press the on/off

button. The display shows “ON”.

∙ Chose temperature or power with the select button .

∙ The temperature can be adjusted with the +/- button in steps of 60 – 80 – 120 – 150

– 180 – 200 – 220 – 240°C. The power can be adjusted in steps of:

∙ right plate: 400 - 600 - 800 - 1000 - 1100 - 1200 - 1300 - 1400 watts

∙ left plate: 300 - 700 - 1000 - 1200 - 1400 - 1600 1800 - 2000 watts

∙ The device starts.

∙ During operation, the temperature or power can be changed.

Timer

∙ If the temperature or power is set and no amendments are made, the device turns

off automatically after 2:59 hours.

∙ Press the timer button . The display shows “0000”, after 5 seconds the device gets

back to normal operation.

∙ Max timer setting is 2 hours 59 minutes

∙ Set the hours with the button.

∙ Set the minutes with the

button.

∙ The time is accepted within 5 seconds and the time begins to count down.

∙ The display shows time and temperature in change.

∙ The time can be changed by pressing the timer button and the +/- buttons.

∙ After the time run out a signal tone sounds and the device switches automatically

into the stand-by mode.

Residual heat

∙ After turning off the device the display shows:

H the temperature of the plate is above 60°C

∙ The ventilation of the device runs for a couple of minutes after the device has been

turn off. Unplug after the ventilation shuts off.

13

Child lock

∙ Press the button . All buttons, except on/off are locked.

∙ In order to unlock, press the button for some seconds.

Troubleshooting

Dear Client,

Thank you for buying this high-quality STEBA product. The following table will help

you with problems that may occur when using your device. For many problems there

is a simple solution, because not everything that appears like a malfunction must be

serious. Please check the following list before sending the complete device to the

customer service for inspection.

Problem Reason Solution

No light after plug-in of

the device

∙ No power

∙ To many devices at one

power cord

∙ Check is plug is

plugged-in correctly

∙ Check the fuse

A signal tone sounds and

no heat occurs

∙ Pot is not in the middle

of the plate

∙ Pot not suitable for

induction

∙ Min. diameter of 12cm

∙ Use suitable cookware

Plate does not heat any-

more

∙ Timer run out ∙ Set a new time

Error code „E0“ ∙ Internal electronic error ∙ Contact service

Error code „E1“ ∙ No or unapproriate

cookware

∙ Check cookware

∙ Let device cool down

and restart

Error code „E2“ ∙ Internal overheat ∙ Check cookware

∙ Let device cool down

and restart

Error code „E3“ ∙ Over-voltage ∙ Contact service

Error code „E4“ ∙ Under-voltage ∙ Contact service

Error code „E5“ ∙ Error in the tempera-

ture sensor

∙ Contact service

Error code „E6“ ∙ Error in the IGBT sensor ∙ Contact service

Error code „E7“ ∙ Top plate overheat ∙ Check cookware

∙ Let device cool down

and restart

14

Guarantee

The guarantee conditions for this appliance are as defined in our „Instructions for

use“ in German.

Correct Disposal of this product

This marking indicates that this product should not be disposed with other

household wastes throughout the EU. To prevent possible harm to the

environment or human health from uncontrolled waste disposal, recycle it

responsibly to promote the sustainable reuse of material resources. To return

your used device, please use the return and collection systems or contact the retailer

where the product was purchased. They can take this product for environmental safe

recycling.

Packaging disposal: Do not throw away the package materials. Please put it in the

recycling bin.

Gift box: Paper, should be put to the old paper collection point.

Plastic packaging material and foils should be collected in the

special collection containers.

Service and Repair:

If the appliance must be repaired, please get in touch with your trader or with the

manufacturer:

STEBA Elektrogeräte GmbH & Co KG

Pointstr. 2, 96129 Strullendorf / Germany

Distribution-Tel.: 09543 / 449-17 / -18,

Service-Tel.: 09543 / 449-44, Fax: 09543 / 449-19

e-Mail: elek[email protected] Internet: http://www.steba.com

Page is loading ...

Steba IK 650 SLIM Owner's manual

This manual is also suitable for

Steba IK 650 SLIM Owner's manual

in other languages

Related papers

Other documents