Format Selection of Multi-view Monitor Output
With the system version 1.02 or later, you can select an output format for the monitor connected to the V-800HD. Depending on
the monitor you are using, select one from below.
The monitor output format of version 1.00 is fixed to Y/Cb/Cr. The resolution and refresh rate are also fixed to 1920 x 1080/60Hz (progressive).
Output Y/Cb/Cr signal
Hold down [1] of the MEMORY buttons and turn the power on.
fig.HDMI-out.eps
Output RGB signal
Hold down [2] of the MEMORY buttons and turn the power on.
* Select RGB output when you are connecting a monitor using a HDMI - DVI conversion cable or the like.
fig.RGB-out.eps
Once you select, the setup is kept and valid from the next booting. While booting, [1] or [2] of the MEMORY will light up in red and enables you to
check your setup.
+
+
Copyright © 2012 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION.
1PS
-
1
