2. Roland
  3. V-800HD

Roland V-800HD Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Roland V-800HD Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Format Selection of Multi-view Monitor Output
With the system version 1.02 or later, you can select an output format for the monitor connected to the V-800HD. Depending on
the monitor you are using, select one from below.
The monitor output format of version 1.00 is fixed to Y/Cb/Cr. The resolution and refresh rate are also fixed to 1920 x 1080/60Hz (progressive).
Output Y/Cb/Cr signal
Hold down [1] of the MEMORY buttons and turn the power on.
fig.HDMI-out.eps
Output RGB signal
Hold down [2] of the MEMORY buttons and turn the power on.
* Select RGB output when you are connecting a monitor using a HDMI - DVI conversion cable or the like.
fig.RGB-out.eps
Once you select, the setup is kept and valid from the next booting. While booting, [1] or [2] of the MEMORY will light up in red and enables you to
check your setup.
+
+
Copyright © 2012 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION.
1PS
/