Webasto 1529 Timer Operating instructions
- Category
- Motorcycle Accessories
- Type
- Operating instructions
This manual is also suitable for
Webasto Thermo & Comfort N.A., Inc.
·
15083 North Road • Fenton, Michigan 48430 Page 1
For Technical Assistance in USA Call: (800) 860-7866 • In Canada Call: (800) 667-8900
Visit us on the Web at: www.webasto.us
Product Information
Summary
Since the launch of the SmarTemp Control fx timers (2014), the Webasto 1529 and 1531 heater displays will be
phased out late in 2015. When upgrading to a SmarTemp Control fx from either the 1529 or 1531 controller,
follow the instructions below.
Conversion Kit P/N: 5011623
Electrical Connection to SmarTemp
Control fx
Wires from 1529 timer connector to be used
Position 6 - Red (B+ Power)
Position 7 - Black (Heater Signal)
Position 5 - Brown (Ground)
Position 8 - Not used (Yellow)
Position 4 - Not used (Violet)
Position 3 - Not used (Gray)
Position 2 - Not used (Blue / Green)
Wires from 1531 timer connector to be used
Position 11 - Red (B+ Power)
Position 2 - Black (Heater Signal)
Position 4 & 12 - Brown or White (Ground)
Position 8 - Not used (Gray)
Position 1 - Not used (Yellow)
Position 10 - Not used (Violet)
After discarding the 1529 / 1531 connector install the supplied spade terminals on the
appropriate wires using the wire descriptions above.
Category: Heater
Document Number: 5011625B
Description:
1529 / 1531 Conversion to SmarTemp Control fx
Date: 7/29/2015 Rev: 8/22/2018
CUT
CUT
Webasto Thermo & Comfort N.A., Inc.
·
15083 North Road • Fenton, Michigan 48430 Page 2
For Technical Assistance in USA Call: (800) 860-7866 • In Canada Call: (800) 667-8900
Visit us on the Web at: www.webasto.us
Product Information
NOTE: If a SmarTemp Control fx is being installed with a Thermo 90S / 90ST heater; PIN 4 (Green Wire) can be
connected to the green wire of the Webasto vehicle side harness to maintain diagnostic blink code functionality.
Mount SmarTemp Control fx
Typical Mounting of a 1529 / 1531
Standard mount directly to surface
(i.e. dashboard)
Standard moutning using “L” brackets
(i.e. below dashboard)
Mount SmarTemp Control fx to existing 1529 / 1531 mounting surface using adpater plate
Standard mount directly to surface
(i.e. dashboard)
Standard moutning using “L” brackets
(i.e. below dashboard)
If you have any questions, contact our technical support team at (800) 860-7866 or via email at:
info-us@webasto.com.
-
1
-
2
Webasto 1529 Timer Operating instructions
- Category
- Motorcycle Accessories
- Type
- Operating instructions
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Webasto Blower Controllers Operating instructions
-
Webasto SmarTemp Control fx 2.0 Installation & Operation Instructions
-
-
-
-
-
-
-
-
