Real Fyre Shoreline Driftwood Owner's manual

Type
Owner's manual

This manual is also suitable for

1
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
LOG SET IMPORTANT INFORMATION
Important: Adequate ventilation is absolutely
necessary. Adequate spacing
between the logs is NECESSARY
and MUST be maintained. Some
carbon build up (sooting) may occur
where fl ames strike the logs. If carbon
build up (sooting) continues, rearrange
top logs to allow more opening(s) for
ame(s) before sooting becomes worse.
If any sooting occurs outside of the
rebox (i.e. on the walls), turn off unit
immediately and contact a qualifi ed
professional service technician.
This product is only warranted when used as part
of a Robert H. Peterson Co. vented burner system.
WARNING: Use ONLY Peterson Real Fyre burners
and valves with this Real Fyre gas log
set. Failure to do so may result in
property damage or personal injury,
and will void listings, certifi cations,
and invalidate claims made to RHP.
Contact your local Real Fyre dealer if you
need more information.
CAUTION...............WARNING...............IMPORTANT
USE ONLY PETERSON REAL FYRE BURNERS AND VALVES WITH THIS REAL FYRE LOG SET.
This instruction contains recommended log placement for these Real Fyre logs which will promote good
combustion and provide superior fl ame pattern and appearance. Use these logs only with a Peterson
burner system.
Adequate ventilation is absolutely necessary! Provided signifi cant, noticeable sooting does not occur,
some fl exibility is possible in log placement to suit your individual preference (see Important below). If you
experience a continued accumulation of black carbon (soot) on your logs it is an indication of incomplete
combustion and you should move the effected log(s) so as to minimize the fl ame contact on the effected
log(s). If signifi cant sooting continues, stop using this gas log set.
Please read these instructions completely and carefully.
L-A2-417REV 0 - 1703290745
SHORELINE DRIFTWOOD LOG PLACEMENT INSTRUCTIONS
SDW-24 shown
2
CAUTION: Burn hazard! Logs will remain hot for some time after
use. If you need to reposition any log to maintain the proper
layout, use heat resistant gloves or allow logs adequate time
to cool before handling.
Failure to use Peterson burners and valves may result in a DANGEROUS
situation and in property damage, personal injury or even death; will
void listings and certifi cations; and will void any insurance coverage
by R.H. Peterson Co or our insurers.
WARNING: This gas log set is for use with R.H. Peterson Co
burners (and parts) ONLY.
L-A2-417
REV 0 - 1703290745
All items for this log set are included in one (1) box.
Log set shown on a P45 Series Burner System.
Sand and/or vermiculite (included with your
burner system) must be poured into the burner
pan prior to ember and log placement. Refer
to the main owner’s manual for sand and/or
vermiculite placement. Then follow the steps
below for glowing ember and log placement.
3
Shoreline Driftwood Log Placement Instructions (18" model)
CAUTION: Burn hazard! Logs will remain
hot for some time after use.
1
2
3
4
Final Log Placement
SDW-18
PARTS LIST
3
8
2
7
5
1
IV
I
II
III
SDWL-12Y
SDWL-15
SDWL-10L
SDWL-12
SDWL-10
4
6
9
SDWL-14
SDWL-11Y
6
SDWL-10Y
SDWL-11
5
EM-1
111
1
1
1
1
1
1
1
I
No embers beyond
pan divider (P45 burner
systems only)
1
V
7
8
9
Place glowing embers
EM-11
Place
bryte
coals
Place logs then separate the bryte coals into
small pieces and evenly place them over the
glowing embers in the area shown.
Bryte coals
Glowing embers
4
Shoreline Driftwood Log Placement Instructions (24" model)
SDW-24
PARTS LIST
4
10
2
11
9
SDWL-15
SDWL-14
SDWL-14L
SDWL-10Y
SDWL-12Y
SDWL-18
5
SDWL-10L
SDWL-12
8
SDWL-11Y
SDWL-11
SDWL-10
7
3
1
6
EM-1
All items for this log set are included in one (1) box.
CAUTION: Burn hazard! Logs will remain
hot for some time after use.
2
1
7
Final Log Placement
9
IV
I
II
III
8
3
V
10
11
Log set shown on a P45 Series Burner System.
Sand and/or vermiculite (included with your
burner system) must be poured into the burner
pan prior to ember and log placement. Refer
to the main owner’s manual for sand and/or
vermiculite placement. Then follow the steps
below for glowing ember and log placement.
Place glowing embers
No embers beyond
pan divider (P45 burner
systems only)
4
5
6
EM-11
Place logs then separate the bryte coals into
small pieces and evenly place them over the
glowing embers in the area shown.
Bryte coals
Glowing embers
Place
bryte
coals
5
Shoreline Driftwood Log Placement Instructions (30" model)
SDW-30
PARTS LIST
5
2
8
SDWL-12
SDWL-14Y
SDWL-10L
SDWL-18
11
SDWL-12Y
13
SDWL-14L
12
SDWL-11
SDWL-16
SDWL-14
10
4
1
SDWL-10
3
SDWL-15
6
SDWL-11Y
SDWL-10Y
7
9
EM-1 (2 bags)
5
4
7
Final Log Placement
9
V
III IV
8
6
VI
13
2
3
II
1
10
11
12
All items for this log set are included in one (1) box.
CAUTION: Burn hazard! Logs will remain
hot for some time after use.
I
Log set shown on a P45 Series Burner System.
Sand and/or vermiculite (included with your
burner system) must be poured into the burner
pan prior to ember and log placement. Refer
to the main owner’s manual for sand and/or
vermiculite placement. Then follow the steps
below for glowing ember and log placement.
For P45, only use 1½ bags of embers. Store
any excess embers in a safe location.
Place glowing embers
No embers beyond
pan divider (P45 burner
systems only)
EM-11
(2 bags)
Place logs then separate the bryte coals into
small pieces and evenly place them over the
glowing embers in the area shown.
Bryte coals
Glowing embers
Place
bryte
coals
6
NOTES PAGE
Please use this page to record any information that you may want to have at hand.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Real Fyre Shoreline Driftwood Owner's manual

Type
Owner's manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI