www.johnsonhardware.com
R
1531/5500 PLBG L.E. JOHNSON PRODUCTS, INC. - 2100 STERLING AVE. - ELKHART, IN 46516 USA- (574) 293-5664 Rev 2/09
#150 POCKET DOOR
EDGE PULL
Place door on edge and brace firmly.
[915mm] from bottom. Use template
two 1/2" [12.5mm] holes at least 3/4"
Drop Edge Pull into slot. Make sure
Mark around edge of face plate with
[2.4mm] deep around inside edge of
screws provided.
5/8"
(15.9mm)
X 3/32" (2.4mm) DEEP
13/16"
(20.6mm)
1-15/16"
(49.2mm)
36"
(914mm)
FROM
DOOR
BOTTOM
3-1/2"
(89mm)
1-1/8" (28.6mm)
DOOR
1-3/8" (35mm)
1-3/4" (44.5mm)
1/2" (12.5mm) DRILL
3/4" (19mm) DEEP
MINIMUM
CLEAN OUT
WITH CHISEL
www.johnsonhardware.com
FOR USE WITH JOHNSON
1500 SERIES POCKET DOOR
FRAMES ONLY
1575 PPK3 POCKET DOOR FRAME
ADAPTER KIT FOR 1/34" THICK DOORS
R
SPLIT STUDS
SPACER
SPACER
SPACER
SPACER
Discard standard Floor Brackets and
replace with 1-3/4" (44mm) Floor Brackets.
Before assembling Split Studs to header,
snap nylon space pads onto top end of
each stud. (Small pins fit into nailer slots
and hold spacers in place). Nail studs into
place as instructed in 1500 assembly instructons.
SPLIT STUD
SPACER
PINS
