Dunlop KH95 Owner's manual

Type
Owner's manual
THE ORIGINAL SINCE 1967
92503008027revD
®
POWER
The Kirk Hammett Signature Cry Baby
®
Wah Wah is powered by one 9-volt battery
(accessed via the bottom of the pedal),
an AC adapter such as the Dunlop
ECB003/ ECB003E, or a DC Brick
power supply.
SETUP INSTRUCTIONS
•Runashieldedinstrumentcablefromyour
guitartotheKH95’sINSTRUMENTjack.
•Runanothershieldedinstrumentcable
fromtheKH95’sAMPLIFIERjackinto
your amplifier input.
•Turnontheamplierandbeginplaying.
•Toturnthepedalon/off,pushthetoeof
the pedal down until you feel a “click”.
•Byrockingyourfootbackandforthon
the pedal, you can change the effect
that the Cry Baby has on the tone of
your instrument instantaneously.
SPECIFICATIONS
Impedance
Input 680 kΩ
Output 4.7 kΩ
Filter Parameter
LowPass 300Hzto380Hz
HighPass 1.4kHzto1.8kHz
Maximum Level
Input -13.5dBV
Output +6.5dBV
Maximum Gain
HeelDown +17dBat300Hzto380Hz
ToeDown +21dBat1.4kHzto1.8kHz
Noise Floor
*
HeelDown >95dBV
ToeDown >89dBV
Bypass Hardwire
Current Draw 4 mA
Power Suppy 9 volts DC
*OdBV
=
1V
RMS,
A-weighted
KH95 KIRK HAMMETT CRy BABy
®
WAH WAH
  • Page 1 1
  • Page 2 2

Dunlop KH95 Owner's manual

Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI