Guardian
®
Automatic Overbed Table
User Instructions
Model IC-6417
POSSIBLE DAMAGE OR INJURY. Be alert of hi/lo adjustment of overbed table
when raising bed.
ASSEMBLY INSTRUCTIONS (FIGURE 1)
1. Place the top board upside down (holes facing up) on the floor. Align table post
with the six pre-drilled holes. Insert and tighten 6 screws to connect post to top
board.
2. Attach the base to the table post using the bolts and washers, and insert as
illustrated.
3. Slide the casters into the base until they lock into place.
4. Set overbed table upright by placing the casters on the floor.
Bolts
Washers
Casters
Table Post
Screws
Top Board
Figure 1
OPERATING INSTRUCTIONS (FIGURE 2)
1. Remove the screw parts located on the table post to adjust the height of the table.
2. To raise the overbed table, apply light pressure underneath the top of the table.
3. To lower, squeeze adjustable plate upwards while pushing the top of the table
downward to desired height.
© 2002 Sunrise Medical 7.02
IM-429007 Rev. A
Manufactured for:
Sunrise Medical, Inc.
7477 East Dry Creek Parkway
Longmont, Colorado 80503
Printed in Taiwan
www.sunrisemedical.com
Phone: (303) 218-4500
Toll Free Phone: (800) 333-4000
In Canada: (800) 263-3390
Adjustable Plate
Table Post
Figure 2
-
1
-
2
Sunrise Medical Guardian Automatic Overbed Table IC-6417 User manual
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Sunrise Medical IC Series User manual
-
-
-
-
-
-
-
-
-
Other documents
-
Invacare Patio Furniture 6418 User manual
-
-
-
-
Seville Classics OFF65905 User guide
-
Drive Medical 13003 Owner's manual
-
-
-
-
