QSC KLA Accessories Quick start guide

QSC
Brand
QSC
Model
KLA Accessories
Type
Quick start guide

This manual is also suitable for

1
KLA AF12
Quick Start Guide
Suspending the KLA Series Loudspeakers
WARNING!: Read and follow these instructions carefully. If the loudspeakers are not suspended properly, they could fall,
causing personal injury and damage to the equipment.
Rules for Suspension
• Consultaprofessionalmechanicalorstructuralengineer,licensedinthejurisdictionofthesoundsysteminstallation,toreview,verify,andapprove
allattachmentstothebuildingorstructure.
• Employtheservicesofacertiedprofessionalriggerforhoisting,positioning,andattachingtheequipmenttothesupportingstructure.
• Correctuseofallsuspensionhardwareandcomponentsisimperativeinsoundsystemsuspensionanddeployment.
• Alwayscalculatesuspendedloadsbeforeliftingtomakesuresuspensioncomponentsandhardwareareusedwithintheirrespectiveloadlimits.
• Consultlocalcodesandregulationstofullyunderstandtherequirementsforsuspendedloadsinthevenueinwhichyouwillsuspend
theequipment.
• UseonlytheKLAAF12ArrayFrameortheM10installationpointsforsuspendingthearray.
• Beabsolutelycertainoftheintegrityofanystructuralmemberintendedtosupportsuspendedloads.Hiddenstructuralmemberscanhavehidden
structuralweakness.
• Neverassumeanything!Ownerorthird-partysuppliedsuspensionattachmentpointsmaynotbeadequateforsuspendingtheloads.
• Beforelifting,alwaysinspectallcomponents(enclosures,suspensionbrackets,pins,frames,bolts,nuts,slings,shackles,etc.)forcracks,wear,
deformation,corrosion,missing,loose,ordamagedpartsthatcouldreducethestrengthoftheassembly.Discardanyworn,defective,orsuspect
partsandreplacethemwithnewappropriatelyload-ratedparts.
Shock Loading
Whenaloadiseithermovedorstopped,itsstaticweightismagnied.Suddenmovementscanmagnifythestaticweightseveraltimes.This
magnicationofstaticweightiscalled"shockloading".Shockloadingposesadangertoequipmentandworkers.Theeffectsofshockloadingcanbe
instantaneous,ormayremainundetectedunlesstheequipmentisvisuallydamaged.Properpreparationforshockloadingrequirescarefulplanning
andknowledgeofequipment,suspension,andliftingpractices.
Shockloadingofequipmentandstructuresisusuallyconnedtoliftingandinstallation,butnaturalforces(winds,earthquakes,andsoon)canimpose
shockloadsseveraltimesthestaticload.Becauseofthis,structuresandsuspensionequipmentmustbecapableofsupportingseveraltimesthe
weightofthesuspendedequipment.
KLA Maximum Suspended Load
TheKLAcomponentsareengineeredfora10:1designfactor.UseaKLA
AF12ArrayFrameortheM10IntegratedSuspensionpointstosuspendone
KLAArrayconsistingofoneofthefollowingarraycongurationoptions.
ThemaximumnumberofKLA12Loudspeakersinanyarray,withorwithout
KLA181Loudspeakers,isve.
Maximum Suspended Loudspeakers per Array
Array Configuration Option A B C
MaximumNumberofKLA181Loudspeakers 2 3 4
MaximumNumberofKLA12Loudspeakers 5 3 0
— Table 1 —
TD-000336-00-A
*TD-000336-00*
3
Assembling the KLA AF12 Array Frame
1. DisassembletheArrayFramefromit'sshippingcongurationbyremovingtheriggingpins.
2. OrientthecorrectfeetdownforKLA12orKLA181.
3. InstallExtensionBarpointingrearward(A)fordowntilt,forward(B)foruptilt.
— Figure 1 —
— Figure 2 —
— Figure 3 —
4
Attaching to a KLA12 Loudspeaker
WARNING!: A KLA Array consists of one of the following array configuration options. The maximum number of KLA12
Loudspeakers in any array, with or without KLA181 Loudspeakers, is five.
1. Referto— Figure 4.Makesurethattheleverslabeled"B"areup,andslides(1)aredownonbothsidesoftheloudspeaker.
2. Referto— Figure 5.PlacetheassembledKLAAF12ArrayFrame,ontopaKLA12.Nestthefourfeet(1)onthearrayframeintothefeetreceptacles
(2)ontheloudspeaker.Makesurethatthesurfacesarealignedandparallel.
3. Onthebottomloudspeaker,pushbutton"A".Slide(1)automaticallymovestoUp Position.
4. RotateLever"B"downtotheLocked Position.
WARNING!: Make sure the loudspeakers are properly aligned, and that the Lever locks are in the down, locked position. Lift
array a small amount to confirm assembly.
— Figure 4 —
1
— Figure 5 —
1
2
— Figure 6 —
ROTATE DOWN
PUSH
1
B
SLIDES UP
5
Attaching to a KLA181 Loudspeaker
WARNING!: A KLA Array consists of one of the following array configuration options. The maximum number of KLA12
Loudspeakers in any array, with or without KLA181 Loudspeakers, is five.
1. Insertthe6mmhexkey(supplied)intothehexsocketonKLA181androtatethekeyfullytotheUnlockedPosition.(Bothsidesofloudspeaker.)
2. PlacetheKLAAF12ArrayFrameontopoftheKLA181,nestingthefourfeet(2)onthearrayframeintothespaces(1)infrontofandbehindthe
attachinghookasshownin— Figure 7.Makesurethatthesurfacesarealignedandparallel.
3. Insertthe6mmhexkeyintothehexsocket(Figure 8, 1)intheKLA181.
4. TurnthekeyfullytotheLockedPositiononbothsidesoftheloudspeaker.Inthenal,LockedPosition,youcanseeasmallportionofthehookin
thebottomoftheviewhole(2).
5. Testtheassemblybytryingtoseparatethetwounits.
— Figure 7 —
1
2
— Figure 8 —
2
1
KLA181
KLA AF12
6
Attaching Rigging Cables to the KLA AF12 Array Frame
WARNING!: AKLA Array can consisting of one of the following array configuration options. The maximum number of KLA12
Loudspeakers in any array, with or without KLA181 Loudspeakers, is five.
1. AttachtheKLAAF12ArrayFrametothesuspensionstructureusinga5/8”(16mm)screwpinanchorshackleandappropriatesling,cable,etc.The
tiltangleofthearraycanbeadjustedbymovingtheshackleforwardsorbackwards.
— Figure 9 —
MailingAddress:
QSCAudioProducts,LLC
1675MacArthurBoulevard
CostaMesa,CA92626-1468USA
TelephoneNumbers:
MainNumber:(714)754-6175
Sales&Marketing:(714)957-7100ortollfree(USAonly)(800)854-4079
CustomerService:(714)957-7150ortollfree(USAonly)(800)772-2834
FacsimileNumbers:
Sales&MarketingFAX:(714)754-6174
CustomerServiceFAX:(714)754-6173
WorldWideWeb:
www.qscaudio.com
E-mail:
[email protected]
[email protected]
[email protected]
© 2011 QSC Audio Products, LLC. All rights reserved. QSC and the QSC logo are registered trademarks of QSC Audio Products, LLC in the U.S. Patent and Trademark office and
other countries. Tilt-Direct, Intrinsic Correction, DEEP and GuardRail are all trademarks of QSC Audio Products, LLC. powerCON is a registered trademark of Neutrik.
All other trademarks are the property of their respective owners. Patents may apply or be pending.
If you would like a full copy of the KLA Series User manual, visit the QSC Audio Products website
at www.qscaudio.com, or contact Customer Service +1 714 957-7150 or toll free (USA only)
(800) 772-2834 to receive a copy by mail.
Si desea obtener una copia completa del manual del usuario de la serie KLA, visite el sitio web
de QSC Audio Products en www.qscaudio.com, o póngase en contacto con el Servicio al Cliente
al +1 714 957-7150 o sin costo (sólo en EE.UU.) al (800) 772-2834 para recibir una copia
por correo.
Pour obtenir un exemplaire complet du manuel d’utilisation de la série KLA, allez sur le site Web
QSC Audio Products à www.qscaudio.com ou contactez le service clientèle au +1 714 957-7150
ou au (800) 772-2834 (numéro vert - USA seulement) pour recevoir un exemplaire par courrier.
Ein vollständiges Exemplar des Benutzerhandbuchs für die KLA-Serie finden Sie auf der QSC
Audio Products-Website unter www.qscaudio.com. Sie können sich unter +1 714 957-7150
oder unter der (nur in den USA) gebührenfreien Nummer +1 (800) 772-2834 auch an den
Kundendienst wenden, um sich ein Exemplar zuschicken zu lassen.
如果您需要 KLA 系列产品用户手册的完整副本，请访问 QSC 音频产品网站 www.qscaudio.
com，或致电客户服务部门 +1 714 957-7150，或拨打免费电话（仅限美国）(800) 772-2834 通
过邮件获取副本。
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

QSC KLA Accessories Quick start guide

QSC
Brand
QSC
Model
KLA Accessories
Type
Quick start guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents