Orion INTELLISCOPE 7880 User manual

Addendum to the

Instruction Manual:

#7880 IntelliScope Computerized

Object Locator for SkyQuest XT

IntelliScope Dobsonians

Because the IntelliScope Computerized Object Locator can now be

used with either SkyQuest XT IntelliScope Dobsonians or SkyView

Pro mounts, it is necessary to initially indicate which mount the

object locator is being used with. This is simple to do, and only needs

to be done once; the object locator will remember which mount-type

has been selected when subsequently powered off.

When you initially switch on the object locator (by pressing the

Power button), the top line should read “POINT VERTICAL”. If it

does, you are ready to use the object locator with your IntelliScope

Dobsonian. If the top line initially reads “ALIGN DEC MARK”, then

simply press the up arrow button. The top line will now read “POINT

VERTICAL”, and you are now set to use the object locator with your

IntelliScope Dobsonian.

Providing Exceptional Consumer Optical Products Since 1975

Customer Support (800)676-1343 • E-mail: support@telescope.com

Corporate Offices (831) 763-7000 • 89 Hangar Way, Watsonville, CA 95076

IN 284 Rev. B 01/09