7
Pusher............................................................................................................................................1 pc.
Coarse grater ...............................................................................................................................1 pc.
Fine grater....................................................................................................................................1 pc.
Coarse shredder ..........................................................................................................................1 pc.
Fine shredder ..............................................................................................................................1 pc.
User manual ................................................................................................................................1 pc.
...........................................................................................................................1 pc.
Manufacturer reserves the right to make any modications to design, packaging, or
technical specications of the product without prior notice.
Meat grinder parts
A1
1. Motor unit
2. ON/OFF button
3.
4. Screw
5. Vegetable cutter unit
6. Dismountable pusher with attachment storage capacity
7. Locking knob
8. Fine shredder
9. Coarse shredder
10. Fine grater
11. Coarse grater
12. Power cord
I . BEFORE USE
stickers.
Be sure to keep in place precautionary stickers, stickers pointers (if applicable) and the
table with serial number on its housing!
After transportation or storage at low temperature allow the appliance to stayat room
temperature for at least 2 hours before use.
completely dry at room temperature before the appliance assembly.
II . OPERATION
1. Prepare products. If necessary, cut them so that they freely pass through the feed
hole.
2.
the auger should align with the slots on the nozzle.
3.
The lock ring marker should align with the
4.
shaft coupling on the motor unit. Rotate the unit counter-clockwise until it
clicks.
5. Put the container for chopped products under the lock ring of the unit.
DO NOT put nuts, coffee beans, ice cubes, sugar and other very rm or coarsely cut
products into the vegetable cutter. It shortens the service life of the appliance and may
lead to its breakage.
DO NOT use the appliance for chopping meat and sh.
6. Plug in the appliance. Press the switch on/off button.
7.
Push food pieces into the tray feed hole using the pusher. Do not try to push
CAUTION! The continuous operation time of the appliance should not exceed 2 minutes.
The idle time should be no less than 5 minutes.
8. To switch off the appliance, repress switch on/off button and disconnect it from
the power outlet.
Overload protection system
from the power outlet and let it completely cool down. Clean the feed hole from the
remaining products and connect the appliance to the power outlet. The appliance will
be ready for operation.
The recommended order of operating the appliance and its nozzles is shown in the
table.