6HD780‐en‐GB_V1.09/16
ViewingMAX‐MIN‐AVG
Foragivenmeasurementsession,thismetercanrecordthehighest(MAX)andthelowest(MIN)
readingsforlaterrecall.
1. PresstheMAX‐MINbuttontoviewthecurrentMAXreadings(MAXiconappears).The
readingsonthedisplayarenowthehighestreadingslogged.
2. PresstheMAX‐MIN
buttonagaintoviewthecurrentMINreadings(MINiconappears).The
readingsonthedisplayarenowthelowestreadingslogged.
3. PressMAX‐MINbuttononcemoretoviewthecurrentAVGreadings(AVGiconappears).
Thereadingsonthedisplayarenowthelowestreadingslogged.
To
exitthe MAX‐MINmode,pressandholdtheMAX‐MINbuttonfor3seconds.TheMAX‐MIN‐
AVGiconswillswitchoffandthemeterwillreturntothenormaloperatingmode.
ZeroAdjust(Pressure)
TheunitmustbekeptintheuprightpositionwhenZEROINGorwhentakingmeasurements.To
ZERO the meter: Before use and without fittings attached to the meter, press and hold the H
buttonfor3secondsoruntilthedisplayshowsallzeroes.
SetupMode
Press and hold the /SET button for three seconds to enter the Setup Mode. Momentarily
pressingtheorbuttonswillcyclethroughoutthefunctions.Press toselectthedesired
function.SetupisdisabledinMIN/MAXmode.Theyare(inorder):
OFFSET………StoreoffsetsforT1andT2
SLP……Sleepmode
Note:PressandholdtheSETbuttonforthreesecondswhenintheSetModetoexit.
Offset
Use the offset option to compensate for a specific thermocouple temperature error or
mismatch.Theallowableadjustmentrangeis±5.0°C(9.0°F).
1. PlugthethermocoupleintotheT1orT2inputconnectorlocatedoneithersideofthemeter.
2. Placethethermocoupleinaknown,stableenvironment.
3. Allow
the readings to stabilize. The primary display shows the temperature, while the
bottomdisplayshowstheoffsetvalue.
4. Use the ▲ and ▼ buttons to adjust the offset until the primary reading matches the
calibration temperature. Press
button to store the value and move to the next setup
modeoption.
SleepMode(AutoPowerOFF)
With sleep mode active, the meter automatically powers off after 20 minutes of inactivity. To
defeatthisfeature,whileinSLPmode,press
toindicateON(sleepmodeON)orOFF(sleep
mode OFF). Press or buttons to make a selection. Press to store the new setting in
memory.