Dudley PNEUMATIC PUSH BUTTON Installation guide

Installation Instructions

nut

button

assembly

PNEUMATIC PUSH BUTTON

(DUAL FLUSH)

0 - 40mm

(max)

150mm

(min)

Mark position of button ensuring there is no

interference with cistern, support frame etc.

and cut hole.

62mm hole

All cistern components must be installed in accordance with UK water regulations.

If in doubt a suitably qualified professional should be consulted.

We pursue a policy of continuing improvement in design and performance of our products.

The right is, therefore, reserved to vary specifications without notice.

Ideal Standard (UK) Ltd. 4815 06/15

CONNECT PNEUMATIC TUBES

Cut pneumatic tubes to the minimum working length

ensuring tubes are not kinked or stretched.

OPERATION

On reduced flush the large button will also travel when the

small button is pressed.

Allow time for cistern to fill before flushing.

Note:- it is normal for the buttons to return slowly after

full flush

Both buttons will give a

full flush if the pipes are

connected the wrong way round

reduced

flush