Installation Instructions
nut
button
assembly
PNEUMATIC PUSH BUTTON
(DUAL FLUSH)
0 - 40mm
(max)
150mm
(min)
Mark position of button ensuring there is no
interference with cistern, support frame etc.
and cut hole.
62mm hole
All cistern components must be installed in accordance with UK water regulations.
If in doubt a suitably qualified professional should be consulted.
We pursue a policy of continuing improvement in design and performance of our products.
The right is, therefore, reserved to vary specifications without notice.
Ideal Standard (UK) Ltd. 4815 06/15
CONNECT PNEUMATIC TUBES
Cut pneumatic tubes to the minimum working length
ensuring tubes are not kinked or stretched.
OPERATION
On reduced flush the large button will also travel when the
small button is pressed.
Allow time for cistern to fill before flushing.
Note:- it is normal for the buttons to return slowly after
full flush
Both buttons will give a
full flush if the pipes are
connected the wrong way round
reduced
flush
/
