2. Comelit
  3. SecurHub Migration to Cloud Next
SecurHub Migration to Cloud Next

Comelit SecurHub Migration to Cloud Next User guide

  • Hello! I've reviewed the document regarding the migration process to Cloud Next. This manual provides step-by-step instructions on how to perform the firmware update, project conversion, and user account migration for Cloud Next. I'm here to help answer your questions about the process, feel free to ask me anything.
  • How do I launch the firmware update?
    What message will I receive during the project conversion?
    What does the account migration tool do?
    What is the first step after firmware update
SecurHub
Migration to Cloud Next
Updating Cloud Next
From version 1.1.x to 1.2.y
2
1. Open project from control panel 1.1.x with a Hub Manager SW version >1.2.0
Updating Cloud Next
From version 1.1.x to 1.2.y
3
2. Launch FW update by selecting the 1.2.y version file in “.vpk”format downloaded previously
Updating Cloud Next
From version 1.1.x to 1.2.y
4
3. You will receive a message stating that the project will be converted automatically
4. Click OK
Updating Cloud Next
From version 1.1.x to 1.2.y
5
5. The project has been converted from 1.1.x to 1.2.y, as shown in the image below
Updating Cloud Next
From version 1.1.x to 1.2.y
6
6. Launch the FW update again, selecting the 1.2.y version “.vpk”
(in this case the update will begin without any other conversion)
Updating Cloud Next
From version 1.1.x to 1.2.y
7
7. At the end of the update the control panel will suggest launching the account migration tool; start it.
Updating Cloud Next
From version 1.1.x to 1.2.y
8
8. Associate the correct account with each receiver, beginning with the end users and ending with the installers
This tool is used to recover accounts (both end users and installers) created previously in the project with the 1.1.x FW version and identified by the first field “App ID” and to migrate
them, i.e. convert them into Cloud accounts for FW version 1.2.y. The tool can be applied at a later date.
Install[email protected]
[email protected]
Continue without any association
Continue without any association
[email protected]
Updating Cloud Next
From version 1.1.x to 1.2.y
9
9. If you review the configuration you will see the end user and installer accounts
End user Installer
[email protected]
Install[email protected]
THANK YOU
/