Comelit SecurHub Migration to Cloud Next User guide

Type
User guide
SecurHub
Migration to Cloud Next
Updating Cloud Next
From version 1.1.x to 1.2.y
2
1. Open project from control panel 1.1.x with a Hub Manager SW version >1.2.0
Updating Cloud Next
From version 1.1.x to 1.2.y
3
2. Launch FW update by selecting the 1.2.y version file in .vpkformat downloaded previously
Updating Cloud Next
From version 1.1.x to 1.2.y
4
3. You will receive a message stating that the project will be converted automatically
4. Click OK
Updating Cloud Next
From version 1.1.x to 1.2.y
5
5. The project has been converted from 1.1.x to 1.2.y, as shown in the image below
Updating Cloud Next
From version 1.1.x to 1.2.y
6
6. Launch the FW update again, selecting the 1.2.y version “.vpk”
(in this case the update will begin without any other conversion)
Updating Cloud Next
From version 1.1.x to 1.2.y
7
7. At the end of the update the control panel will suggest launching the account migration tool; start it.
Updating Cloud Next
From version 1.1.x to 1.2.y
8
8. Associate the correct account with each receiver, beginning with the end users and ending with the installers
This tool is used to recover accounts (both end users and installers) created previously in the project with the 1.1.x FW version and identified by the first field “App ID” and to migrate
them, i.e. convert them into Cloud accounts for FW version 1.2.y. The tool can be applied at a later date.
Continue without any association
Continue without any association
Updating Cloud Next
From version 1.1.x to 1.2.y
9
9. If you review the configuration you will see the end user and installer accounts
End user Installer
THANK YOU
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10

Comelit SecurHub Migration to Cloud Next User guide

Type
User guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI