TFJ0

Dryflow TFJ0 User manual

  • Hello! I am an AI chatbot trained to assist you with the Dryflow TFJ0 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
TurboForce Junior Plus
user manual
2
260x180x152mm
Air speed
Cover
If you dont use this unit properly or follow the safety guidelines carefully,
it would lead to serious personal injury or potential damage.
Do not open the front panel. Otherwise,
you may get an electric shock.
Do not let children hang from the unit. Otherwise,
this may cause the unit to drop.
Do not allow
the unit to
get wet
Do not allow the unit to get wet. Otherwise,
it will cause electric shock
Do not use in a wet environment, for example, near the
bathroom where it may get the direct water and the
places where condensation may form. Otherwise,
this may cause electric shock and unit malfunction.
Please do
comply with
instructions
Power must be cut off during maintenance to prevent the
risk or electric shock.
Air filter must be installed.
o fire.
Attention when installing:
Do not install when the machine has power connected.
No touch hand drying ensures complete hygiene.
Stainless steel cover, solid and beautiful appearance.
The machine is equipped with automatic heating system,
when temperature is cold, it automatically opens the
heating system, when the temperature is hot, the heating
system automatically shuts down.
No need for paper towels, ease of maintenance
.
IP13
TurboForce Junior PLUS 3
1.01.5
400
Place with temperature below -10 or over 40
be 100mm or above)
Cover
Cover
cover.
As figure shows, the machine is to be
fixed on the wall by screws.
The machine has been equipped with a
power cord. If needing junction box for
installation,the power cord must be
removed.
As figure shows, the wire is drawn out
through thread hole to the terminal
blocks to connect.
Connect the power supply line
Cover removal
Keeping the cover carefully avoiding
scratching.
Using allen wrench from accessories
bag to remove 2 countersunk screws
from cover.
Pull the cover upward by hands to
remove.
Please confirm whether your hands
are far away from the sensor parts
if there is no air blowing out.
Place your hands
in the drying area
High speed air blown out
If not correctly installed the
machine will shake and rattle.
Power socket must be matching
the machine plug.
Please check the power when
the indicator light is off.
Cover installation
7 Riverside Court, Don Road
Sheffield, S9 2TJ. UK.
Tel: +44 (0)114 3540047
www.dryflow.co.uk
Clean with a soft dry cloth or towel.
Otherwise, this will damage the machine
surface finish or produce discoloration.
Rub the hands together.
Place the back of the
hands under the airflow.
Move backwards and
forwards.
Place the palms of the
hands under the airflow.
Move backwards and
forwards.
/