Samsung LACH-R1-B User manual

DVM S2 Low ambient coolingJXDUGPRGHOV LACH-R1-B, LACH-R2-B

Parts included: Rear low ambient cooling guard, installation screws

NOTE:

•To prevent personal injury or damage to the outdoor unit, it is recommended that at least two (2) people

install the guard.

•The outdoor unit must install 12" minimum above the ground or 18" minimum above anticipated

snowfall depth ("h", Figure: A), whichever is higher.

•Clearance around the outdoor unit must be at least 18" greater than standard clearances

("unrestricted" wall height clearances in outdoor unit installation manual) when using LACH-R1-B,

LACH-R2-B.

WARNING: This product has sharp edges. Wear protective clothing, eye protection, and gloves during installation

to prevent personal injury.

ATTENTION: Take extreme care during installation to prevent damage to the outdoor unit coil.

3. Insert and tighten the screws from step 1 in the screw holes from the screen removed in step 1.

1. Remove rear coil guard screen from the outdoor unit and discard. Save the screws.

2. Carefully lift the guard up to the unit lining up the screw holes on the left and right sides of the guard taking care not to

scratch the outdoor unit finish.

4. Secure the guard to the unit using all provided screw holes. Never use screws longer than the screws that are included

with LACH-R*-B to prevent damage to outdoor unit components.

Low Ambient Cooling Guard Installation Instructions (Back)

www.SamsungHVAC.com

•LACH-R1-B and LACH-R2-B guards are designed to be used in conjunction with LACH-1-B,

LACH-2-B, and LACH-3-B low ambient cooling hoods and LACH-SL-B and LACH-SR-B side guards.

Side, rear and a front (for applicable models) guards and a low ambient cooling hood must be used

for low ambient cooling applications. Figure: A

SHA-LACH-B-11102022