Bauknecht ARC 0760 User guide

Type
User guide
PRODUCT SHEET
GB
IGBD F NL E P GR
DK
S N FIN
A. Refrigerator compartment
1.
Crisper drawer
2.
Shelves / Shelf area
3.
Thermostat control knob/light
4.
Shelves
5.
Rating plate (at the side of crisper
drawer)
B. Low temperature compartment
6.
Ice cube tray (if provided, inside the
compartment)
7.
Low temperature compartment door.
Least cold zone
Intermediate temperature zone
Coldest zone
Notes
: The number of shelves and type of accessories may vary, depending on the model.
All shelves and racks are removable.
Important: Refrigerator accessories must not be washed in a dishwasher.
6gb33026.fm5 Page 1 Wednesday, February 28, 2001 5:03 PM
I
5019 602 33026
GBD F NL E P GR
DK
S N FIN
Printed in Italy 02/01
Refrigerator compartment controls
A.
Light switch cam
B.
Thermostat control
reference
C.
Thermostat knob
D.
Switch (if provided)
E.
Light bulb (max 15 W)
Thermostat set to
MIN/1-2
:
minimum
refrigeration.
Thermostat set to
MED
/
3-4
:
medium
refrigeration.
Thermostat set to
MAX/5-7
:
maximum
refrigeration.
Thermostat set to
z
:
no refrigeration
,
no light.
Recommended thermostat setting: MED/3-4 position.
Optimal performance is obtained at temperatures between +16°C and +32°C for appliances with climatic
class N and at temperatures between +10°C and +32°C for appliances with climatic class SN.
The climatic class is indicated on the data plate inside the appliance.
Note
: The ambient air temperature, the frequency of door opening and the position of the appliance can
affect the internal temperatures of the refrigerator. These factors must be taken into account when setting
the thermostat.
Removing the light bulb
To remove the light bulb, unscrew it anticlockwise (see figures).
Posizioning the appliance under the
worktop
The appliance can be installed under a
worktop (worktop height 850 mm from floor).
Proceed as follows:
First loosen the rear
A
and front
B
screws; then remove the appliance top
(
Fig.1
).
Make a vent outlet on the worktop (
Fig. 2
).
Push the appliance under the worktop and
secure at the front with the same screws
B
used for the top.
Observe the distance from the rear wall
indicated in (
Fig. 2
)
FIG. 1
FIG. 2
6gb33026.fm5 Page 2 Wednesday, February 28, 2001 5:03 PM
  • Page 1 1
  • Page 2 2

Bauknecht ARC 0760 User guide

Type
User guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI