2. JRCO
  3. 125S.JRC

JRCO 125S.JRC, 125L.JRC Owner's manual

  • Hello! I've reviewed the user manual for the JRCO Receiver Hitch Mount and 504U Electric Broadcast Spreader. This document provides detailed instructions on how to assemble the hitch components, connect the electrical system, and mount the spreader. I'm ready to answer your questions about the installation process or the features of the hitch system described in the document.
  • How do I attach the hitch extension to the broadcaster?
    How do I attach the receiver hitch to a John Deere Gator front bumper?
    What is used to secure the hitch extension to the receiver hitch?
    How do I connect the battery harness?
2" Hitch
Adapter
Hitch Extension
Hitch
Receiver
Backing
Plate
1. Attach the Hitch Extension to the Broadcaster using the bumper u-bolt, two 3/8-16 x 3/4
hex head bolts and four 3/8 nylon locknuts as shown.
2. Attach the Receiver Hitch.
John Deere Gator front hitch - Bolt the receiver to the bumper using the backing 
plate and four 1/2-13 x 2 1/2" hex head bolts.
John Deere Gator rear hitch - Bolt the receiver hitch to the Gator frame using four 
1/2-13 x 1" hex head bolts and nylon locknuts.
John Deere Gator HPX front hitch - bolt the receiver hitch to the Gator HPX frame 
using four 1/2-13 x 1" hex head bolts and nylon locknuts.
3. Secure hitch extension to receiver hitch with a 1/2-13 x 1 1/4" hex head bolt. Tighten to
eliminate wobble.
4. Connect battery harness to Utility Vehicle battery. Attach red wire to positive (+), and
black wire to ground/negative (-).
5. Mount electronic speed control on Utility Vehicle near operator. Connect to motor with
supplied harness extension.
Tighten Draw Bolt
Bumper
U-bolt
Electronic
Speed Control
is196 JRCO, Inc. Minneapolis, MN 800-966-8442 www.jrcoinc.com
Note: Not all models include all hitch parts
504U Electric
Broadcast Spreader
JRCO Utility Vehicle Receiver Hitch Mount
Battery Harness
Motor/ESC
Harness Extension
/