JRCO 125L.JRC Owner's manual

Brand: JRCO

Model: 125L.JRC

Type: Owner's manual

This manual is also suitable for

125S.JRC

2" Hitch

Adapter

Hitch Extension

Hitch

Receiver

Backing

Plate

1. Attach the Hitch Extension to the Broadcaster using the bumper u-bolt, two 3/8-16 x 3/4

hex head bolts and four 3/8 nylon locknuts as shown.

2. Attach the Receiver Hitch.

 John Deere Gator front hitch - Bolt the receiver to the bumper using the backing 

 plate and four 1/2-13 x 2 1/2" hex head bolts.

 John Deere Gator rear hitch - Bolt the receiver hitch to the Gator frame using four 

 1/2-13 x 1" hex head bolts and nylon locknuts.

 John Deere Gator HPX front hitch - bolt the receiver hitch to the Gator HPX frame 

 using four 1/2-13 x 1" hex head bolts and nylon locknuts.

3. Secure hitch extension to receiver hitch with a 1/2-13 x 1 1/4" hex head bolt. Tighten to

eliminate wobble.

4. Connect battery harness to Utility Vehicle battery. Attach red wire to positive (+), and

black wire to ground/negative (-).

5. Mount electronic speed control on Utility Vehicle near operator. Connect to motor with

supplied harness extension.

Tighten Draw Bolt

Bumper

U-bolt

Electronic

Speed Control

is196  JRCO, Inc. Minneapolis, MN  800-966-8442 www.jrcoinc.com

Note: Not all models include all hitch parts

504U Electric

Broadcast Spreader

JRCO Utility Vehicle Receiver Hitch Mount

Battery Harness

Motor/ESC

Harness Extension