Memory Module Specification
1.700
0.700
0.000
0.000
0.040
0.965
2.625
5.250
1 84
R .078 2 PLCS
R .040 2 PLCS
85
168
PLL
REG
16M x 8-Bit
TSOJ
16M x 8-Bit
TSOJ
16M x 8-Bit
TSOJ
16M x 8-Bit
TSOJ
16M x 8-Bit
TSOJ
16M x 8-Bit
TSOJ
16M x 8-Bit
TSOJ
16M x 8-Bit
TSOJ
16M x 8-Bit
TSOJ
16M x 8-Bit
TSOJ
16M x 8-Bit
TSOJ
16M x 8-Bit
TSOJ
16M x 8-Bit
TSOJ
16M x 8-Bit
TSOJ
16M x 8-Bit
TSOJ
16M x 8-Bit
TSOJ
16M x 8-Bit
TSOJ
16M x 8-Bit
TSOJ
REG
REG
2156
DESCRIPTION:
This document describes ValueRAM's 32M x 72-bit (256MB) PC100 CL2 (CAS Latency 2)
ECC Registered SDRAM (Synchronous DRAM) memory module. The components on this
module include eighteen 16M x 8-bit (4M x 8-bit x 4 bank) SDRAM CL2 PC100 components
in TSOP packages. This 168-pin DIMM uses gold contact fingers and requires +3.3V. The
electrical and mechanical specifications are as follows:
FEATURES:
CLK Cycle Time (tCK) min. = 10ns (CAS Latency = 2) / max. = 1000ns
Row Cycle Time (tRC) 70ns
CLK to Output (tAC) max. = 6ns (CAS Latency = 2)
Single Power Supply of +3.3V (+/- .3V)
Power 7.194 W (operating)
UL Rating 94 V - 0
Document No. VALUERAM0053-001.B00
02/27/02
Figure 1: KVR100X72RC2/256 168-Pin SDRAM Module
KVR100X72RC2/256
PC100 Registered SDRAM 168-Pin
CL2 ECC DIMM Memory Module
Note: All measurements are in decimal inches.
Note: The module defined in this data sheet is one of several configurations available under this part number. While
all configurations are compatible, the DRAM combination and/or the module height may vary from what is described
here. However, in no configuration will the module height exceed 1.700" (43.18mm).