32
Overview of the Components / Delivery Scope
1 Lid
2 Seal ring of lid
3 Stirring tool
4 Seal ring of tool holder
5 Handle
6 Multifunction button
7 Power cable
8 Base
9 Jug
10 Tool holder
11 Froth beater
Unpacking the Appliance
1. Remove the packaging of the appliance.
2. Remove all packaging material such as plastic lm, ller
material, cable ties and box packaging.
3. Check that all the parts are in the box.
4. Do not operate the appliance if package contents is
incomplete or appear damaged. Return it immediately to
the dealer.
NOTE:
There may still be dust or production residues on the
appliance. We recommend that you clean the appliance as
described under “Cleaning”.
Notes on Use
Location
A skid-proof, even surface is suitable as installation location.
Electrical Connection
1. Ensure that your mains power corresponds with the spec-
ications of the appliance. The specications are printed
on the type label.
2. Connect the mains cable to correctly installed and earthed
socket.
Multifunction button
Press 1 x = Hot (glowing red)
Press 2 x = Warm (ashing red)
Press 3 x = Cold (glowing blue)
Press 4 x = Off
Jug
Should you remove the jug from the base during operation
and replace it on the base within approx. 1 second, the previ-
ously selected function will continue.
Seals
The tool holder and the lid are equipped with a seal. Be sure
that the seal rings are always properly secured in place.
Capacity
The jug holds between 120 and 300 ml. Refer to the scale
on the jug:
MAX
120 ml (maximum quantity for frothing)
MAX
300 ml (maximum quantity for stirring)
Frothing Milk
CAUTION:
Observe the capacity marking MAX
, otherwise the milk
will foam over.
NOTE:
• For optimum results use milk with 3.5 % fat content and
ll in 200 ml.
• Milk with 1.5 % fat content and soy milk or lactose-free
milk does not froth as well.
Heating up Drinking Chocolate / Hot Chocolate
CAUTION:
• Please add cocoa or chocolate only after you have lled
in the milk.
• Cut the chocolate into little pieces and do not ll in too
much chocolate.
• Do not ll above the MAX
mark, otherwise the
beverage will overow.
• If you want to make hot chocolate, take off the froth
beater.
Usage Table
For information about how to use the milk frother please refer
to this table:
Usage - desired result
Mixing
attachment
Multifunction
button
Hot frothed milk Froth beater Press 1 x
Hot stirred milk Stirring tool Press 1 x
Steamed milk Froth beater Press 2 x
Warm stirred milk Stirring tool Press 2 x
Cold foamed milk Froth beater Press 3 x
Cold stirred milk Stirring tool Press 3 x
Hot Chocolate Stirring tool Press 1 x
Operation
1. Place the desired attachment on the tool holder. Place the
tool holder with the attachment centrically in the jug.
2. Fill the liquid into the jug.
3. Put on the lid.
4. Place the jug on the base.
5. Depending on the desired application, press the button
once, twice or three times .