Assembly & Setup
Star Trac E-SM Stairmill Installation Checklist
Use the checklist below to ensure proper installation of Star Trac Stairmill:
Identify all parts and hardware from packaging are accounted for
Verify the correct console is paired with the unit
Verify all wiring leading up to the console is zip tied to the frame
Ensure all bolts are tightened so specifications outlined in the installation manual
Verify battery voltage is at least 6.2 volts and the unit is equipped with a power supply and is plugged
in and wall power has been turned “on” within maintenance mode
Verify the chain tension is with specifications given by Star Trac (dumbbell test)
Verify the alignment of the steps is true when rotating the steps. If it is not adjust upper/lower
sprockets, or step chains for true alignment
Verify the neck is mounted accurately
Ensure the pause switch is firmly connected into the console
Verify the wireless heart rate board is in place and secured inside the console
Verify the unit wakes up upon use and is initialized for proper function
Ensure the auto fan is turned “on” and verify the proper function of the fan
Verify default settings in the maintenance mode as outlined in the owner’s manual
Verify the programs are functioning properly under load
Test heart rate function in a program and in maintenance mode with hand grips and polar strap
Test quick start and pause buttons are functioning properly
Ensure proper shroud installation, check for loose shrouds and adjust as needed
Level the unit to the floor and check for any wobble when set in place
Overall visual & cosmetic inspection: All equipment is to be wiped down and checked for defects prior to
leaving the facility. Installer is to contact an authorized Core Health & Fitness representative while on site, if
there are any issues that have not been resolved.
STAR TRAC FITNESS 0 of 1 637-XXXX
