Edsal Bookcase Wall Fastening Directions Assembly Manual

Drill two (2) appropriate hole sizes in the back of the unit

(hole size will vary based on type of hardware purchased).

Measure approximately eight (8) to ten (10) inches from

the side panel outside edge toward the inside of the back.

Measure approximately ten (10) to twelve (12) inches

down from the top. Where the two points meet, drill the

first hole.

Repeat the process for the opposite side.

Fasten the unit to the wall using the hardware purchased

making sure the hardware is properly tightened and that

the unit now is secure.

Use the illustration below for assistance on proper hole

placement.

Right Side

Left Side

Top

Hole Approximately:

eight (8) to ten (10)

inches inward from side

(opposite side also)

Hole Approximately:

ten (10) to twelve (12)

inches down from the top

(opposite side also)

Hardware through holes, and fasten to wall

Wall

Note: For use with 72” & 84” models only

Back Of The Unit

After assembly is complete, this unit

MUST BE SECURED TO A WALL.

FAILURE to mount the unit to a wall

can create a TIPPING HAZZARD.

A tipping hazard can be dangerous to your-

self, and others. See your local hardware

store to purchase the anchor hardware to

properly suit the installation

of mounting this unit to a wall.