2. ARP
  3. Water Butt Deflector Kit

ARP Water Butt Deflector Kit Installation guide

  • Hello! I'm the chat assistant. I've reviewed the Installation Guide for the Water Butt Deflector Kit. This document provides clear instructions on connecting your water butt to the downpipe using the included flexible tubing and connectors. The guide covers essential steps like measuring, drilling, cutting the downpipe and installation of the diverter. I'm ready to help with any questions you might have about its installation.
  • How much flexible tubing is supplied?
    How many tank connectors are included?
    What is the maximum distance for the water butt from the downpipe?
ii
Any cut lengths should be de-burred and touched up with touch-up paint supplied prior to installation.
For more information or further assistance, please contact us.
T: 0116 289 4400 | E: sales@arp-ltd.com | www.arp-ltd.com
Taking a level from the bottom of your drilled hole, mark
a line on the downpipe and then a further line 70mm
higher. Cut the downpipe at both marks and support.
Installation Guide
WATER BUTT DEFLECTOR KIT
Please note that the kit supplied is made up of 500mm of exible tubing plus 2no tank connectors, of which
only one connector is needed.
Remove items from the pack and put in a safe place,
along with the rainwater diverter.
Make sure that the water butt is on level ground and
positioned no more than 500mm from the downpipe.
Measure 100mm from the top of the butt and mark it.
Using a hole saw, drill a hole and t the tank connector.
Manoeuvre the diverter onto to downpipe and attach a
pipe clip to support the diverter.
2
1
3 4
5
500mm max500mm max
100mm
XXXX
6
Attach the exible hose to both the water butt connector
and the diverter. Replace the water butt lid.
/