Quartz Pendulum Wall Clock
Operating Instructions
To Start the Clock: Insert (2) new AA batteries into the battery compartment, making sure to
align the (+) and (-) ends of the battery to match the description on the battery compartment.
Important Note: In some clocks both batteries face the same direction.
Remove the protective film from the pendulum and place the pendulum at the bottom of the
swinging pendulum arm. Ensure the arm is not hooked into the safety latch to the side of the bat-
tery compartment. If the arm is in the safety position, the pendulum won’t swing. To release from
the safety position, simply pull out so the pendulum is centered when the clock is upright.
To Set the Time: At the back of the clock, gently turn the knob clockwise until the desired time
is set on the front of the dial.
The quartz accuracy built into our clocks provide masterfully precise time keeping. It is recom-
mended that a battery inspection be made if the time becomes inaccurate, as this is an indication
of a low battery. When necessary, replace the battery for optimum performance. Standard AA
batteries will last approximately one year under normal clock operation.
Important Reminders:
Please do not use liquid detergent, abrasive material or solution to clean the clock. If cleaning is
warranted, a simple soft cloth is generally all that is necessary.
When cleaning glass, use a non-ammonia glass cleaner. Never spray the cleaner directly on the
clock.
Avoid exposing the clock to direct sunlight or high intensity lighting which may fade the finish.