2. LG
  3. 27ART10AKPL

LG 27ART10AKPL Quick setup guide

  • Hello! I've reviewed the user install guide for the LG StandbyME 27ART10AKPL. This document provides step-by-step instructions for assembling the stand, securing the power cord, and mounting the screen. The guide also includes directions for disassembling the device. I'm ready to help with any questions you might have about the installation or disassembly process.
  • How do I insert the stand base?
    How many screws are used to secure the stand?
    What should I do after positioning the screen vertically when disassembling the cover?
    What is the correct way to lift the plug when disassembling the screen ?
1
M4L34
M4L10
Head
washer
AA
1X4X
Installation
A Insert the stand base into the styrofoam groove as shown in the gure.
B Insert the bar into the hole of the stand base along the groove until it reaches the parting line.
C Secure the four screws.
>10 kg A
M4L34
4X
B
C
www.lg.com
User Install Guide
*MFL718845022201rev01*
4
M4L10
1X
B
A
B
A
A B
Power cable
Power plug
Cable holder
3Hold the screen and secure the power plug.
ACheck the position of the power plug on the back cover of the screen.
BSecure it tightly to the back cover side.
2Check the orientation of the power cable and cable holder.
Secure the screen to the stand.
A Insert the stand hook into the back cover groove and tighten
while pushing the lower part, as shown in the gure.
(Push it until you hear a [click] sound.)
B Secure one screw to the cable holder.
5Secure the ring cover of the stand.
AAlign the screen back cover and ring cover [●mark] and install them.
BCheck if it sits tightly as shown in the gure.
ART10*
www.lg.com
*MFL718019722303rev04*
1
4
Disassembly
Position the screen vertically. 2Push the top of the screen lightly in the
direction of the arrow to disassemble
a part of the cover space. 3Use a wedge or pull it with your hand
to completely disassemble the cover.
Position the screen horizontally and
disassemble the cable holder screw. 5Lower the rear lever and push the bottom
of the screen forward, as shown in the figure. 6Lift the screen, separate the top
of the screen, and hold the screen.
7Press the plug lock, push it in the direction of the arrow,
and then disassemble the screen completely. 8Lay the stand on the box packaging, remove the four screws,
and then disassemble the stand bar.
※ Caution
Avoid pushing it hard.
There is a risk of damage.
※ Do not lift the plug or pull it downward
when disassembling the screen.
Keep the disassembled screen
close to the stand at a distance
of 10 cm or less.
M4L10
1X
M4L34
4X
Plug lock
Kg
AB C D E F F G
27ART10AKPL 621
最大 / Max.
1268 397 361 29.9 17.5 4.8
最少 / Min.
1068
19V 4.0A
90°
Head
washer
ղࢶQU
৮ࢿػ੉޷૑ࠂઁೞৈ
1BUIGJOEFS6OJUF৻ࢶઁ੘
QU"MJHOTUSPLFPVUTJEF
:
/