amazon.com/AmazonBasics
Quick Start Guide
Quick Start Guide
Quick Start Guide
Quick Start Guide
Quick Start Guide
Quick Start Guide
B085CY1MP9, B085CY76VL
MADE IN CHINA
FABRIQUÉ EN CHINE
HERGESTELL IN CHINA
PRODOTTO IN CINA
HECHO EN CHINA
GEMAAKT IN CHINA V01-00/00
Pull at the thread to pull it out, and wind it around
the bobbin winding tension disc.
Then, wrap the thread around the bobbin a few
times to secure it. Slide the bobbin pin to the right
to lock the bobbin in place for winding.
Apply gentle pressure to the foot pedal to begin loading
the bobbin with thread. When the required amount of
thread is loaded, remove pressure from the foot pedal.
Slide the bobbin pin back to the left and remove the
bobbin from the bobbin pin.
Step 1 - Wind the Bobbin Step 2 - Threading the Upper Half of the Machine
Place your thread spool on the spool pin
and put the thread spool cover on top.
Place your thread spool on the spool pin
and put the thread spool cover on top.
Pull at the thread to pull it out, and wrap the
thread around the thread guide.
Follow the directional arrows on your sewing
machine by pulling the thread through the thread
guide and towards you. Ensuring the thread is
centralised, you should be making a long and
narrow “U” shape with your thread.
Feed the thread through the take up lever.
Make sure you are inserting the thread
from the right hand side of the hole.
EN EN
Step 2 - Threading the Upper Half of the Machine Step 3 - Threading the Bobbin Through the Machine
Once you’ve threaded up the upper half of the
machine, remove the bobbin cover and insert
your loaded bobbin.
Slide the bobbin cover back on and
ensure that the presser foot is raised.
Thread the needle in to the eye of the needle.
Gently pull the bobbin’s thread ensuring that the
bobbin spins clockwise.
Feed the thread to the left ensuring that
the thread is tucked in to the inside of
the bobbin.
Ensure that your thread has been fed through
the final directional arrow marked on the
machine and feed your thread through the metal
hole at the top of the needle.
EN EN
Changing the Needle
Remove the needle and dispose of it safely.
Hold the thread that is through the needle
with your left hand and turn the hand wheel
with your right hand. Watch the bobbin as you
turn the hand wheel.
Step 3 - Threading the Bobbin Through the Machine
When you see a loop pass over the top of the
bobbin, continue turning the hand wheel until
the needle is raised.
Pull the thread through until you see
a loop appear out of the machine.
Pinch the loop and pull the threads until all of
the bobbin’s thread is through the machine.
Your machine is now ready to use.
Turn off your machine, remove thread from
the needle and use the hand wheel to
position your needle at the highest point.
Take your new needle and position it so that the flat
side is facing away from you. Put the needle back in
to the needle hole and tighten the needle clamp by
turning it away from you.
Gently hold on to the needle with your left hand and
loosen the needle by turning the needle clamp
towards you.
EN EN
Fabric Guide
EN EN
Correctly Threaded Machine
Correct Incorrect
Upper Half of Machine Upper Half of Machine
The thread should be taut and fed
centrally through the thread guides.
The thread shouldn’t be slack and
falling outside of the thread guides.
Threads shouldn’t be slack and
unthreaded through the thread guides.
The Bobbin must be fed through the
machine before use.
Thread should be taut and fed through
all of the thread guides and the bobbin
should be fed through the machine.
Needle Needle
Cotton/Linen
Regular
Thick
Thin
Hard
Soft
Silk/Wool Polyester Elastic Denim
Easy to Sew Harder to Sew Difficult to Sew
/
