Kamado Joe KJ15041123 Stainless Steel Firebowl Operating instructions

I've reviewed the instruction sheet for the Konnected Joe KJ15041123/KJ15041523 stainless steel firebowl replacement. The document details step-by-step instructions for safely disassembling and reassembling the grill, focusing on removing and replacing the firebowl. It highlights important safety precautions and component removal sequences. I'm ready to assist with any specific questions you might have about this process or the features mentioned in document.
What should I do before handling the grill?

What internal components need to be removed?

What is the first step in removing firebowl?

KJ15041123/KJ15041523

CAUTION - SAFETY PRECAUTIONS - READ BEFORE USE

• Make sure your grill has fully cooled before handling to avoid burns.

• Some components may have sharp edges. Use caution to avoid injury.

• Disconnect the power supply from the grill before handling.

Instruction Sheet Code: 9804220063 221118-GH

Konnected Joe™

Stainless Steel Firebowl

Remove all internal components of

the grill. Cooking grates, x rack, heat

deflectors, SS ring, ceramic firebowl

panels, charcoal grate, element.

Remove the set screw from the

inside of the grill (front).

Remove the set screw from the

outside of the grill (rear).

Remove 12 hinge acorn nuts.

Remove the hinge.

Remove the lid and set aside.

Install the disengagement tool on

the hinge. Unplug pit probe, lid

switch, and power supply from

rear of grill.

Remove the 2 acorn nuts from the

element mounting plate. Then, with

extreme caution, lift the element

straight up and out of the grill. (NOTE

- you may need to lightly hold down

the element bracket to remove the

element from the bracket).

Remove the charcoal grate from

the grill

DISENGAGEMENT

TOOL

Remove the three wire harness

cover screws. Remove the wire harness cover.

Unplug the element from the wire

harness. The element wire can

be identified with the yellow and

white wire.

Remove front module and set aside.

Loosen two screws from rear module.

Please note, the screws do not have to

be fully removed to disengage the

rear module.

Remove rear module and set aside.

Remove two screws from front module.

Remove the ceramic ring from the grill.

Remove the stainless steel

firebowl from the grill.

Remove the front insulation.

Remove ash drawer assembly and

rear insulation. Note - the rear

insulation is secured with the ash

drawer assembly.

Repeat the steps in reverse order to install the new stainless steel firebowl kit.

NOTE – when installing the new ash drawer assembly, make sure the flanges go

through the front and rear of the grill body.

FRONT FLANGE REAR FLANGE

Kamado Joe® Premier Specialty Brands, LLC, 5032 Milgen Ct., Columbus, GA 31907 USA kamadojoe.com/pages/contact

Kamado Joe Europe, Lange Voorhout 86, 2514 EJDen Haag, Netherlands [email protected]

Kamado Joe UK Limited, 3 Maritime House, The Hart,Farnham, GU9 7HW, England [email protected]