The setup process consists of a few simple steps:

1) Connect Almond+(Wireless Router) to the Internet in “Router” or “Range Extender” mode.

2) [Optional] Setup your Almond+(Wireless Router) Account to enable remote access for your sensors.

3) [Optional] Pair sensors to your new Almond+(Wireless Router).

Inside the Box

Desk Stand

Wall Plate

12V, 2.5A Power Adapter

Gigabit

1) Unplug the AC adapter & ethernet cables of your Internet modem (Cable, DSL or Fiber). If your

modem has a battery remove it.

2) Wait for 1 minute. If your modem has a battery re-insert it. Plug the AC adapter of the modem back

into the power outlet.

3) Wait for 1 minute. Plug the AC adapter of Almond+(Wireless Router) into the power outlet.

4) Follow the on-screen instructions on Almond+(Wireless Router)'s Touch Screen.

This typically involves the following steps:

1) On the Almond+(Wireless Router) LCD, inside the “Add sensor” section tap “Add”.

2) Set the sensor/device in pairing mode as per its instructions.

Controlling Sensors and Almond+(Wireless Router)

1) Almond+(Wireless Router) iOS App

2) Almond+(Wireless Router) Android App

3) Remote Web Interface: https://connect.securifi.com

4) Local Browser Interface: http://10.10.10.254 (default)

You can edit these settings in the “Wireless” app on the LCD.

Please note that the Range extender by default creates a new wireless network with Almond+(Wireless Router) appended to your

original network’s name.

Some routers don't allow you to connect range extenders. Please try using the “Wireless WAN” app on the LCD for such routers.

Join our Forums

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no guaran-

tee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio

or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one of the following measures:

● Reorient or relocate the receiving antenna.

● Increase the separation between the equipment and receiver.

● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

not cause harmful interference, and (2) this device must accept any interference received, including interference that may

cause undesired operation.

For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not

possible.

This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.

conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including inter-

ference that may cause undesired operation of the device.

For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not

possible.

This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This

equipment should be installed and operated with minimum distance 20cm between the radiator & your body.

When suing IEEE 802.11a wireless LAN, this product is restricted to indoor use, due to its operation in the 5.15 to 5.25GHz

frequency range. The FCC requires this product to be used indoors for the frequency range of 5.15 to 5.25GHz to reduce

the potential for harmful interference to co channel mobile satellite systems.

High-power radar is allocated as the primary user of the 5.25 to 5.35GHz and 5.65 to 5.85GHz bands. These radar

stations can cause interference with and/or damage to this device.