Hyundai H-DVR18HD User manual

Category
Drive recorders
Type
User manual
АВТОМОБИЛЬНЫЙ
ВИДЕОРЕГИСТРАТОР
CAR VIDEO RECORDER
Руководство по эксплуатации Instruction manual
H-DVR18HD
2
Instruction Manual
Dear customer!
Thank you for purchasing our product. For safety, it is strongly recommended to read
this manual carefully before connecting, operating and/or adjusting the product and keep
the manual for future reference.
If you want to dispose of this product, do not mix it with general household waste. There
is a separate collection system for used electronic products in accordance with legislation
that requires proper treatment, recovery and recycling.
Please contact your local authorities for the correct method of disposal. By doing so, you
will ensure that your disposed product undergoes the necessary treatment, recovery and
recycling and thus prevent potential negative effects on the environment and human health.
Utilization of the product
Important safeguards
• Carefully read through the manual to
familiarize yourself with the device.
• Keep the manual handy as a reference for
operating procedures and precautions. Do not
allow persons who have not read this manual
to use the device.
• Connect the device only to the vehicle
lighter jack of your car with +12-24 V DC
power. If the voltage is too high, it may damage
the device.
• Careful handling of the device can prolong
its operation life.
• Due to variety of car lighter jack sizes
depending on vehicle type, make sure the
device is properly plugged in the lighter socket.
• The device should be used only
with original accessories included. The
Manufacturer is not responsible for possible
damage of the device caused by using
other accessories than provided by the
Manufacturer.
• If this product malfunctions or fails to
operate properly, contact your local dealer.
Controllers
Front view
1 2
1. Reset hole
2. Lens
Rear panel
3 4 5 6 7 8 9
1110
3
Instruction Manual
3. Speaker
4. Display
5. UP ( ) button
6. DOWN ( ) button/SOS
7. MODE button
8. REC (OK) button
9. MENU button
10. Microphone
11. Status indicator
Top panel
12 13
14
12. POWER button
13. microSD card slot
14. Bracket
Side panels
15
16
17
15. Mini HDMI port
16. Mini USB port
17. TV-OUT interface
Operations
Mounting
• Insert the mounting pin on the top of the
holder into the bracket on the unit and slide
until a click to fix it tightly to the holder.
• Press the suction cup to a flat surface in
the car, then push the pressure valve down.
Make sure the holder is properly fixed to the
surface.
• You can adjust the angle of the holder
by loosening the washer and bending the
assembly knot.
• To unmount the holder, lift the pressure
valve, then lift the plastic ear on the suction cap.
Power and charging
To charge the battery connect the MiniUSB
port on the device to the PC with the supplied
USB cable; or connect it to a car lighter socket
with the supplied car adapter. The power
icon in the top right corner of the display
indicates the remaining battery power. The time
taken by complete charging of the battery is 3
hours.
Recording
• Before you start recording, insert a MicroSD
memory card into the memory card slot of this
unit until a click. Insert the card with correct
side. After the card is inserted the devce will turn
off in order to preserve the information. Press
POWER button to turn it on again.
MicroSD capacity supported: up to
32 Gb, class 6 or higher. For correct and
satisfactory operation, licensed MicroSD
memory cards of famous brands should be
used with this unit. Avoid using memory cards
of unknown brands.
• Auto recording: After you connect this unit
to car power source, recording will be started
automatically. After you disconnect the power
source, the unit will stop recording and save
the recorded information.
• Manual recording: Press POWER button
to switch on the unit (press and hold it again if
you want to switch off the unit). If necessary,
select recording mode by pressing MODE
button. Press ОК button to start recording.
Press this button again to stop recording.
• While recording, the recording time
is shown in white figures in the bottom of
the display. The unit will save video files
automatically after each 1, 3 or 5 minutes (see
“Setup“ paragraph below for more details).
When the memory card is filled, old files will
be deleted and the new files will be recorded
instead. Press ОК button to stop and to
4
Instruction Manual
continue recording.
• Before removing memory card stop
recording. Press on the card until a click to
remove it.
• SOS function. When you press the DOWN
button during video recording, the current
fragment will be protected from rerecording.
• G-sensor. If overload resulting from an
impact exceeds the setup value (1 g = 9.8m/s^2;
see “Setup“ paragraph below for more details),
the current video fragment will be automatically
saved and protected from re-recording.
Warning: The G sensor is working only if
stabilization mode is switched on (it is switched
on by default). G-sensor is switched off by
default.
Photo mode
• When recording is not on, press MODE
button to choose the photo mode. Press ОК
button to take a photo.
• You can set various parameters of photo.
Please see “Setup“ paragraph below for more
details.
Playback mode
• When the device completes the switch-on
program and enters the video mode, press the
MODE button to enter the replay mode, press
the UP/DOWN buttons to browse images and
videos. In replay mode, you may browse the
files by categories only; if the chosen file type
is video, you can only browse videos; if image,
you may only browse images.
• In playback mode you can delete and
protect files (see “Setup“ paragraph below for
more details).
AV output and HDMI output
• Connect the AV output of this unit to an
external audio-video device (e.g. car TV) with
a 3.5 mm monophonic audio-video cable (not
included). Now this unit can be used as audio
and video signal source for the external device.
• Connect the HDMI output of this unit to an
external audio-video device (e.g. car TV) with
the supplied HDMI cable. Now this unit can be
used as high-quality digital signal source for
the external device.
PC connection
• USB drive: After this unit is connected to
the PC via USB cable,choose MSDC function,
it is a computer interface between a computer
and a digital camera which shows the digital
camera as a removable disk drive attached to
the computer.
• PC camera: After this unit is connected
to the PC via USB cable, choose PCCAM
function and, after installation of the driver, you
can use the device as your PC camera.
If you contact the device via USB cable
to your computer for the first time, and the PC
cannot see it, please plug off the cable and try
again.
It may be caused by poor contact of the
cable and the USB port.
This device supports the following operating
systems: Windows 2000/XP/Vista/Windows 7,
MAC OSX 10.3.6 or above
Display auto-off
To enable the display auto-off function, open
the Power Save setting in General system
setup, choose between 10 sec. or 30 sec., and
after the designated time the display will turn
off automatically. Press any key to turn it back
on.
Setup
In recording or photo mode press MENU
button to display the current mode setting
menu. In the menu press UP/DOWN buttons
to select settings. Press ОК button to go to
adjustment of the selected setting; select
options with the UP/DOWN buttons and press
it to confirm. Press MENU button to exit from
the menu.
The menu in your unit may be changed
without prior notice and hence be different from
the menu described below.
5
Instruction Manual
General system setup
• G-sensor: On/Off
• File type: Event/Video/JPEG image.
• Sounds:
-Voice recording: On/Off
-Beep: On/Off
-Volume
• Power save: Off/10sec/30 sec
• Date/time: set the current month, year,
day, hour and minute and the date display
mode by pressing UP/DOWN buttons and
pressing OK button to select an item.
• Language: select the on-screen menu
language.
• Light freq.: 50/60 Hz
• TV out: NTSC/PAL
• Format: SD card. After you select «Ok»
option, the connected memory card will be
formatted.
• System:
-Factory reset
-System info
-Card info
Video setup
• Resolution: select video resolution:
FHD(1080P)/HD(720P).
• Loop recording: Off/1 minute/3 minutes/5
minutes. Select the record fragment time.
• Date Stamp: on/off. Activate or deactivate
showing of date in the recorded video.
• Motion detection: on/off. Activate or
deactivate motion detector for video recording.
Photo setup
• Image resolution: 12M/10M/8M/5M/2M.
Select the size and resolution of the image.
• Exposure: Set the exposure -2/-1/0/+1/+2
Playback mode setup
• In replay mode, press the MENU button
and select DELETE. Press UP/DOWN buttons
to enter the options and choose between
“Single” and “All”. Press OK button to confirm.
• Protect: You may add a lock to the file.
You cannot delete it before unlocking. In such
way, some important files can be protected.
Accessories
Video recorder 1 pc
Car adaptor 1 pc
MiniUSB-USB cable 1 pc
Holder 1 pc
HDMI cable 1 pc
Instruction Manual 1 pc
Consumer information 1 pc
Warranty card 1 pc
6
Instruction Manual
Specifications
Lens view angle 120
0
Display ColorTFT, 1.5”
Light sensitivity 1 lux
Video resolution 1080P/720P
Video record format AVI
Photo format JPEG
Interfaces miniUSB (2.0)/3.5 mm audio-video out/mini HDMI out
Built-in battery 300 mAh
Operation period 36 min
Nominal voltage 3.7 V
Current consumption 1000 mA/5 V
Cycled recording +
Motion detector +
G-sensor +
Max record fragment 5 minutes
Memory MicroSD memory card, up to 32 GB
Operation temperatures -10
0
С - +60
0
С
Storage temperatures -20
0
С - +70
0
С
Unit dimensions 95 х 40 х 24 mm
Net weight 0.05 kg
Specifications are subject to change without notice. Weights are approximate.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13

Hyundai H-DVR18HD User manual

Category
Drive recorders
Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI