Hyundai H-DVR18HD User manual

АВТОМОБИЛЬНЫЙ

ВИДЕОРЕГИСТРАТОР

CAR VIDEO RECORDER

Руководство по эксплуатации Instruction manual

H-DVR18HD

2

Instruction Manual

Dear customer!

Thank you for purchasing our product. For safety, it is strongly recommended to read

this manual carefully before connecting, operating and/or adjusting the product and keep

the manual for future reference.

If you want to dispose of this product, do not mix it with general household waste. There

is a separate collection system for used electronic products in accordance with legislation

that requires proper treatment, recovery and recycling.

Please contact your local authorities for the correct method of disposal. By doing so, you

will ensure that your disposed product undergoes the necessary treatment, recovery and

recycling and thus prevent potential negative effects on the environment and human health.

Utilization of the product

Important safeguards

• Carefully read through the manual to

familiarize yourself with the device.

• Keep the manual handy as a reference for

operating procedures and precautions. Do not

allow persons who have not read this manual

to use the device.

• Connect the device only to the vehicle

lighter jack of your car with +12-24 V DC

power. If the voltage is too high, it may damage

the device.

• Careful handling of the device can prolong

its operation life.

• Due to variety of car lighter jack sizes

depending on vehicle type, make sure the

device is properly plugged in the lighter socket.

• The device should be used only

with original accessories included. The

Manufacturer is not responsible for possible

damage of the device caused by using

other accessories than provided by the

Manufacturer.

• If this product malfunctions or fails to

operate properly, contact your local dealer.

Controllers

Front view

1 2

1. Reset hole

2. Lens

Rear panel

3 4 5 6 7 8 9

1110

3

Instruction Manual

3. Speaker

4. Display

5. UP ( ) button

6. DOWN ( ) button/SOS

7. MODE button

8. REC (OK) button

9. MENU button

10. Microphone

11. Status indicator

Top panel

12 13

14

12. POWER button

13. microSD card slot

14. Bracket

Side panels

15

16

17

15. Mini HDMI port

16. Mini USB port

17. TV-OUT interface

Operations

Mounting

• Insert the mounting pin on the top of the

holder into the bracket on the unit and slide

until a click to fix it tightly to the holder.

• Press the suction cup to a flat surface in

the car, then push the pressure valve down.

Make sure the holder is properly fixed to the

surface.

• You can adjust the angle of the holder

by loosening the washer and bending the

assembly knot.

• To unmount the holder, lift the pressure

valve, then lift the plastic ear on the suction cap.

Power and charging

To charge the battery connect the MiniUSB

port on the device to the PC with the supplied

USB cable; or connect it to a car lighter socket

with the supplied car adapter. The power

icon in the top right corner of the display

indicates the remaining battery power. The time

taken by complete charging of the battery is 3

hours.

Recording

• Before you start recording, insert a MicroSD

memory card into the memory card slot of this

unit until a click. Insert the card with correct

side. After the card is inserted the devce will turn

off in order to preserve the information. Press

POWER button to turn it on again.

MicroSD capacity supported: up to

32 Gb, class 6 or higher. For correct and

satisfactory operation, licensed MicroSD

memory cards of famous brands should be

used with this unit. Avoid using memory cards

of unknown brands.

• Auto recording: After you connect this unit

to car power source, recording will be started

automatically. After you disconnect the power

source, the unit will stop recording and save

the recorded information.

• Manual recording: Press POWER button

to switch on the unit (press and hold it again if

you want to switch off the unit). If necessary,

select recording mode by pressing MODE

button. Press ОК button to start recording.

Press this button again to stop recording.

• While recording, the recording time

is shown in white figures in the bottom of

the display. The unit will save video files

automatically after each 1, 3 or 5 minutes (see

“Setup“ paragraph below for more details).

When the memory card is filled, old files will

be deleted and the new files will be recorded

instead. Press ОК button to stop and to

4

Instruction Manual

continue recording.

• Before removing memory card stop

recording. Press on the card until a click to

remove it.

• SOS function. When you press the DOWN

button during video recording, the current

fragment will be protected from rerecording.

• G-sensor. If overload resulting from an

impact exceeds the setup value (1 g = 9.8m/s^2;

see “Setup“ paragraph below for more details),

the current video fragment will be automatically

saved and protected from re-recording.

Warning: The G sensor is working only if

stabilization mode is switched on (it is switched

on by default). G-sensor is switched off by

default.

Photo mode

• When recording is not on, press MODE

button to choose the photo mode. Press ОК

button to take a photo.

• You can set various parameters of photo.

Please see “Setup“ paragraph below for more

details.

Playback mode

• When the device completes the switch-on

program and enters the video mode, press the

MODE button to enter the replay mode, press

the UP/DOWN buttons to browse images and

videos. In replay mode, you may browse the

files by categories only; if the chosen file type

is video, you can only browse videos; if image,

you may only browse images.

• In playback mode you can delete and

protect files (see “Setup“ paragraph below for

more details).

AV output and HDMI output

• Connect the AV output of this unit to an

external audio-video device (e.g. car TV) with

a 3.5 mm monophonic audio-video cable (not

included). Now this unit can be used as audio

and video signal source for the external device.

• Connect the HDMI output of this unit to an

external audio-video device (e.g. car TV) with

the supplied HDMI cable. Now this unit can be

used as high-quality digital signal source for

the external device.

PC connection

• USB drive: After this unit is connected to

the PC via USB cable,choose MSDC function,

it is a computer interface between a computer

and a digital camera which shows the digital

camera as a removable disk drive attached to

the computer.

• PC camera: After this unit is connected

to the PC via USB cable, choose PCCAM

function and, after installation of the driver, you

can use the device as your PC camera.

If you contact the device via USB cable

to your computer for the first time, and the PC

cannot see it, please plug off the cable and try

again.

It may be caused by poor contact of the

cable and the USB port.

This device supports the following operating

systems: Windows 2000/XP/Vista/Windows 7,

MAC OSX 10.3.6 or above

Display auto-off

To enable the display auto-off function, open

the Power Save setting in General system

setup, choose between 10 sec. or 30 sec., and

after the designated time the display will turn

off automatically. Press any key to turn it back

on.

Setup

In recording or photo mode press MENU

button to display the current mode setting

menu. In the menu press UP/DOWN buttons

to select settings. Press ОК button to go to

adjustment of the selected setting; select

options with the UP/DOWN buttons and press

it to confirm. Press MENU button to exit from

the menu.

The menu in your unit may be changed

without prior notice and hence be different from

the menu described below.

5

Instruction Manual

General system setup

• G-sensor: On/Off

• File type: Event/Video/JPEG image.

• Sounds:

-Voice recording: On/Off

-Beep: On/Off

-Volume

• Power save: Off/10sec/30 sec

• Date/time: set the current month, year,

day, hour and minute and the date display

mode by pressing UP/DOWN buttons and

pressing OK button to select an item.

• Language: select the on-screen menu

language.

• Light freq.: 50/60 Hz

• TV out: NTSC/PAL

• Format: SD card. After you select «Ok»

option, the connected memory card will be

formatted.

• System:

-Factory reset

-System info

-Card info

Video setup

• Resolution: select video resolution:

FHD(1080P)/HD(720P).

• Loop recording: Off/1 minute/3 minutes/5

minutes. Select the record fragment time.

• Date Stamp: on/off. Activate or deactivate

showing of date in the recorded video.

• Motion detection: on/off. Activate or

deactivate motion detector for video recording.

Photo setup

• Image resolution: 12M/10M/8M/5M/2M.

Select the size and resolution of the image.

• Exposure: Set the exposure -2/-1/0/+1/+2

Playback mode setup

• In replay mode, press the MENU button

and select DELETE. Press UP/DOWN buttons

to enter the options and choose between

“Single” and “All”. Press OK button to confirm.

• Protect: You may add a lock to the file.

You cannot delete it before unlocking. In such

way, some important files can be protected.

Accessories

Video recorder 1 pc

Car adaptor 1 pc

MiniUSB-USB cable 1 pc

Holder 1 pc

HDMI cable 1 pc

Instruction Manual 1 pc

Consumer information 1 pc

Warranty card 1 pc

6

Instruction Manual

Specifications

Lens view angle 120

0

Display ColorTFT, 1.5”

Light sensitivity 1 lux

Video resolution 1080P/720P

Video record format AVI

Photo format JPEG

Interfaces miniUSB (2.0)/3.5 mm audio-video out/mini HDMI out

Built-in battery 300 mAh

Operation period 36 min

Nominal voltage 3.7 V

Current consumption 1000 mA/5 V

Cycled recording +

Motion detector +

G-sensor +

Max record fragment 5 minutes

Memory MicroSD memory card, up to 32 GB

Operation temperatures -10

0

С - +60

0

С

Storage temperatures -20

0

С - +70

0

С

Unit dimensions 95 х 40 х 24 mm

Net weight 0.05 kg

Specifications are subject to change without notice. Weights are approximate.

Page is loading ...

Hyundai H-DVR18HD User manual

Hyundai H-DVR18HD User manual

in other languages

Related papers

Other documents