Paradyne COMSPHERE 3920 Important information

December 2000

Firmware Compatibility Notice

Due to the discontinuation of a memory circuit, COMSPHEREr Models 3810Plus, 3811Plus, 3920,

and 3921 have a new design. This new design contains hardware that will only operate correctly with

current and future versions of firmware. This affects models stamped with serial number 5106805

and greater. If you download a previous version of firmware to a model with serial number 5106805 or

greater, the unit will not operate correctly. You will then need to dial in to the Download Center

(number below) and download the correct firmware to restore the unit.

Modems with serial number 5106805 or greater will operate correctly only with the following firmware:

H Models 3810Plus, 3811Plus: Release P3.31.03 or above

H Models 3920, 3921: Release M4.11.02 or above

The serial number can be found on labels on the shipping carton and the modem. Firmware revision

level can be verified using the Status branch of the shared or integral Diagnostic Control Panel: select

Identity, then FRev#.

The modem this notice is shipped with already has compatible firmware loaded.

All versions of these modems are interoperable, and the new models can reside in a network where

some modems are at a previous software release. So updating existing networks to the new code is

not a requirement. However, Paradyne recommends that you run current firmware throughout your

network. This makes maintenance easier and allows you to enjoy the latest enhancements.

Update the firmware in your existing modems to the current software version by dialing the Download

Center at 1-727-530-7026 or by going to Paradyne’s Web site (www.paradyne.com) and

downloading the appropriate current release.

*3900-A2-GK40-30*

*3900–A2–GK40–30*

This manual is also suitable for

Download PDF