Page 2
Page 3
SAFETY DIRECTIONS
IMPORTANTSAFEGUARDS
When using an electrical appliance, basic precautions should always be followed, including
the following;
READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER.
WARNING
To reduce the risk of fire, electric shock or injury;
•
Do not use outdoors.
•
Do not leave the vacuum cleaner plugged in. Turn off the power switch and unplug the power
cord when not in use or before servicing.
•
Do not allow it to be used as a toy. Great care should be taken when used by or near children.
•
Use only as described in this manual. Only use attachments recommended by the manufacturer.
•
Do not use the vacuum cleaner if the cord or plug is damaged.
•
Do not pull or carry the vacuum cleaner by pulling on the cord, do not use the cord as a handle,
do not close the door on the cord, or pull the cord around sharp edges or corners. Do not place
the vacuum cleaner on the cord. Keep the cord away from heated surfaces.
•
Do not use extension cords or outlets with an inadequate current carrying capacity.
•
Turn off all controls before unplugging.
•
Do not unplug by pulling on cord. To disconnect, grasp the plug, not the cord.
•
Do not handle the plug or vacuum cleaner with wet hands or operate without shoes.
•
Do not put any objects in the openings. Do not use with any blocked opening; Keep it free of
dust, lint, hair and anything that can reduce airflow.
•
This vacuum cleaner creates suction and contains a rotating brush. Keep hair, loose clothing,
fingers and all body parts away from openings and moving parts.
•
Do not pick up anything that is burning like cigarettes, matches or hot ashes. • Do not use
without the dust cup or filter in place.
•
Use extra care when cleaning stairs.
•
Do not use to collect flammable or combustible liquids such as gasoline, or to use in areas where
they may be present.
•
Store your cleaner in a cool, dry place.
•
Be sure to turn the unit off at least every 15 minutes (for 1 minute) to cool the engine. Failure to
do so may result in engine failure.
•
DO NOT use this unit for more than 4 hours (including breaks).
Page 4
PARTS NAME
Sliding block
Extension
tubes
Floor
brush
Handle
Blower
Power
tool
socket
Hose
connector
Dust
barrel
Hose
Metal handle -
NOT on HYVI32
Switch
Carrying
handle
Locking
lever
Power
cord/plug
Wheel
Carpet use
Floor use
Water pick- up use
Floor brush
For carpets and
wooden floors etc.
Crevice nozzle, for
corners, cracks etc
Bristle brush, for sofa,
bookshelf, curtain,
furniture etc
Page 5
OPERATION
METHOD
Release the locking levers to
open-up the housing, take out
the wheels and accessories
Locking block
1. Install castor wheels into the hole on the base.
2. Install the big wheel into the relevant position and
then fix the wheel with screw.(Please kindly keep the
mark on the big wheel (“R” or “L”) same as the one
(“R” or “L”) on wheel base.
Assemble the metal handle as shown in image - N.B.
The HYVI32 does not have a handle.
Put the hose connector into ①, the suction
function is available
Put the hose connector into ②, the blow
function is available
Hose connector
Page 6
OPERATION
METHOD
Handle
Extension tube
Insert the handle into the tube with
a twisting force
Extension tube
Insert the handle into the tube with
a twisting force
Extension tube
Floor brush
Insert the handle into the tube with
a twisting force
Tube storage
Page 7
OPERATION
METHOD
Hold the plug and insert into socket
N.B. The HYVI32 does not have a handle.
ON/OFF Switch When choosing the "AUTO" button the vacuum
cleaner operates when the power tool is used;
The vacuum cleaner stops working after the
power tool is turned off.
Only by choosing button "1", the vacuum cleaner
works, but the power tool does not work. When
the "AUTO" button and the "1" button are on the
same level, the vacuum cleaner and power tool
will not operate because electricity is cut off.
Disconnect power tool when adjusting plug or
vacuum switch.
The maximum load of the power tool plug is
2000W.
You can adjust the airflow by
pushing the sliding block UP and
DOWN
Page 8
TO REPLACE DUST BAG
When the dust barrel is full you must empty it as soon as possible
Release the locking lever to
open-up the housing
Locking lever
N.B. The HYVI32 does not have a handle.
Empty the dust barrel
Put the dust barrel back on
the housing and fasten the
locking levers
Page 9
MAINTENANCE
WARNING; When the filters and covered with dust or the suction decreases considerably,
please clean the filters. This will improve the working efficiency and extend the life of the
cleaner. NEVER use the machine without filters
Remove the mesh
Mesh
Remove the mesh outside the HEPA filter
Twist the locking knob with an anti-clockwise
force and take off the filters
Clean filter carefully
Dry by airing
Replace the filter
Page 10
SPECIFICATION
Air Flow (CBM/Min) 1.8 ± 0.1
Dust capacity (L) 30 L
Motor type Low noise 1200W motor
Wattage (W) 1200 W
Voltage/Frequency 220-240V/50Hz
Flexible hose 1.5m x Φ32 mm
G.W/N.W 10.0/9.0 KG
Fully assembled dimensions 415mm x 386mm x 744mm
In the box Main unit – Flexible hose –
Wet dry floor brush –
Stainless steel extension tube –
Crevice nozzle –
Dusting brush
To register your product for the manufacturer’s warranty, please visit:
https://hyundaipowerequipment.co.uk/warranty
WARRANTY
Page 11
DECLARATIONS of CONFORMITY
Genpower Ltd confirms that this Hyundai product conform to the following CE
Directives;
2006/42/EC Machinery Directive
2004/108/EC EMC Directive
2006/95/EC Low Voltage Directive
HYUNDAI Corporation
25, Yulgok-ro 2-gil, Jongno-gu,
Seoul 03143, Korea,
Post Code : 03143
Copyright 2016 HYUNDAI Corporation All rights reserved.
Made in P.R.C
Imported into UK
by GENPOWER
GENPOWER LTD
Isaac Way, London Road
Pembroke Dock, UNITED KINGDOM, SA72 4RW T:
+44 (0) 1646 687 880 F: +44 (0) 1646 686 198
E: info@hyundaipowerproducts.co.uk
www.hyundaipowerproducts.co.uk
/