eMachines T4060 Bios Manual

Hello! I am an AI chatbot trained to assist you with the eMachines T4060 Bios Manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

T4060 BIOS Flash

After downloading the self-extracting BIOS flash utility and the BIOS flash instructions

from the drivers section of the web site, follow the instructions below to flash your

system BIOS.

WARNING ! Interrupting, or powering off your system during the flashing process

could permanently damage your system.

1. Insert a blank floppy disk into the floppy disk drive, and click the OK button.

NOTE: If there are any files on this disk, they will be erased.

2. The files will now be extracted to the floppy disk in drive A:

3. When the extraction process has completed, leave the floppy in the floppy drive,

and restart the system.

4. A short flash utility will take place

5. When complete, you will see on the screen the DOS A> prompt.

6. At this point remove the floppy disk from the floppy drive, and restart the

system.

7. After you restart the system you will see a message on the screen that

states “CMOS Checksum Error - Defaults Loaded” “Press F1 to continue

or DEL to enter Setup”

8. At this point press the <F1> key to continue.

9. The system will then boot into Windows XP and you have now completed

the BIOS update process.