8
HOW TO USE THE APPLIANCE
• We do not recommend laminating any type of self-developing photo.
• Any photo to be laminated must be dry before processing.
• Do not laminate any documents that appear thick or heavy, as they will get stuck in
the laminator. If this occurs, please contact your local service centre for servicing.
• This product bonds the laminate sleeve to the items processed. It is a permanent
seal and cannot be removed.
• We do not recommend laminating any collector’s items of value or any item you
may wish to remove at a later date. Do not attempt to laminate coins or thicker items.
1. Before operation, select a suitable temperature according to your pouch thickness.
2. To switch the laminator on, press the tilt switch to the right (hot). The red light is
illuminated. When the green light is also illuminated, the device is ready to start
laminating. The laminator requires about 3 – 5 minutes to heat up.
3. For cold lamination, press the tilt switch to the left (cold). The red and green lights
are illuminated. Now, you can start laminating. If hot lamination was previously
completed, only the red light will be initially illuminated. Please wait 40 – 60 minutes
until the laminator cools down. When the green light is also illuminated,
the laminator is ready to use.
4. Place the item to be laminated into the laminating sleeve, centring it within the sleeve.
Please make sure your document or picture is positioned as close to the sealed edge
as possible.
• The laminator does not require the use of a carrier in order to operate.
• The laminator can laminate pouches from 80 microns to 125 microns.
It works with most types of heat-sealing laminating pouches.
5. Insert the sealed edge of the laminating sleeve straight into the CENTRE of the
laminator opening.
6. Remove the sleeve from the rear of the machine after is has stopped moving.
7. Some types of paper do not laminate evenly, or appear somewhat cloudy.
In such cases, the lamination can be fed through the machine a second time and
the lamination process may be repeated.
8. If any materials are jammed in the laminator, please use the reverse switch (Ill. 1, No. 11).
1 Power switch (cold/off/hot)
2 LED indicator (function LED)
3 Housing base
4 Film insert direction
5 Decorative cover
6 Max. laminating line
7 Housing top
8 Document tray
9 Power cord
10 Pouches select switch (80 – 125 micron transfer)
11 Reverse switch (forward – reverse)
12 LED indicator (power LED)
fig. 1
Manual__A3Premium:Layout 1 11.10.10 12:55 Seite 8