Assembly
Assembling the Tinsel Santa with Train
Step1. Unfold the Engine (C) and insert the hook on one side into the matching hole at the opposite
corner inside the panel. Insert the rod of the Exhaust Stack (B) into the top of the Engine. Insert the rods
on the bottom of the Smoke (A) Into the top of the Exhaust Stack. Secure all Parts to each other with
the with Plastic Ties (P). (FIG.1)
Step2. Insert the rod on the Santa's Body (E) into the front edge of The Train Body (F). Insert the rods
on the Arms (D) into the matching holes on the Santa Body. Secure all Parts with Plastic Ties. Attach
the rods on the back of the Engine into the matching holes on the front edge of the Train Body (F).
(FIG.1)
Step3. Unfold the First Car (I) and insert the hook on one side into the matching hole at the opposite
corner inside the panel. Insert the rod of the Deer's Body (H) into the front edge of the First Car .Insert
the rods at the bottom of the Deer's Head (G) Into the Deer's Body. (FIG.2)
Step 4. Unfold the Second Car (L) and insert the hook on one side into the matching hole at the
opposite corner inside the panel. Insert the rods at the bottom of the Gift Box (J) and Tree (K) into the
Second Car. (FIG.3)
Step 5. Secure the Train to the ground with the Ground Stakes (M). (FIG.4)
Pre-Operation
CAUTION: Grasp the plug to insert or remove from the power source. Do
not unplug by pulling on cord.
CAUTION: The lighting string on this product is rated at 86.4 Watts
(0.72Amps). Do not overload. Do not connect to other lighting strings, decorative outfit or
other electrical products. Before you use or re-use this product inspect it carefully. Return
to Store or discard if the product has cuts, damage or frayed wire insulation on
cords, cracks in the socket enclosures, loose connections or exposed copper wire.
Care and Cleaning
a. Carefully remove the product from wherever it is placed. This helps to avoid any undue
strain or stress on the product, wire and lighting connections. If the product is placed
somewhere other than the ground it should be well secured and stable.
b. Wipe the unit with a damp cloth and allow the unit to dry before storing.
c. Store the product neatly in a cool, dry location protected from sunlight.
FOR INDOOR AND OUTDOOR USE
C
A
B
D
E
F
G
H
I
J
FIG.1
FIG.2
FIG.3
FIG.4