WASHING
MACHINE
FH0B8WDL2
FH0B8WDL24 FH296HDL24
FH0B8NDL21
FH296HDL23
FH0B8NDL2
P/NO : MFL67584554
Rev. No.: 00
Please read this manual carefully before operating
your washing machine and retain it for future reference.
FH8B8NDL22 FH0B8NDL25 FH096WDL24
FH0B8NDL22
MFL67584554
FH096WDL23
Page is loading ...
Page is loading ...
No Spin/400/800/1200 [FH296HDL24 / FH296HDL23]
No Spin/400/800/1000 [FH0B8NDL2 / FH0B8WDL2]
No Spin/400/600/800 [FH8B8NDL22]
[FH0B8NDL25 / FH096WDL23]
6.0kg : [FH0B8NDL2 / FH0B8NDL25 / FH0B8NDL22 / FH0B8NDL21]
6.5kg : [FH0B8WDL2 /
/ FH0B8WDL24 / FH096WDL23 / FH096WDL24]
7.0kg : [FH296HDL23 / FH296HDL24]
[FH8B8NDL22]
[FH096WDL24 / FH0B8NDL22/ FH0B8NDL21 / FH0B8WDL24]
leg
Adjustable
Lower cover
Door
Drawer
(For detergent and
fabric softener)
Power Plug
Control Panel
Drum
Drain Pump Filter
Drain Plug
Lower Cover Cap
If the supply cord is damaged,
it must be replaced by the
manufacturer or its service agents
or a similarly qualied person in
order to avoid a hazard.
Packing Support
carpeted floor.
subjected
in
caused
Unpacking
Cut the straps and open the upper aps of Packing box & take out the Anti Rat Cover.
While taking out the Machine from packing, please take due care in removing packing
support given at centre of the base packing.
Anti Rat Cover is
placed below the upper
aps of the Packing
box.
Anti Rat Cover installation
Accessories for xing Anti Rat Cover.
1. Take out the poly bag (containing Screws/Washers).
2. Tilt the machine sideways.
3. Bend & insert the aps of Anti Rat Cover into the bottom side of machine.
4. Assemble the Anti Rat Cover on the bottom side of the machine by using
Screws & Washers.
Machine.
5
adjustable legs
It is advisable to avoid, the usage of trolley & the movement of Washing Machine after installation.
As it may disturb the levelling of washer, which can create excessive noise & vibration.
6
Part can be different according to different models.
(0.3~10kgf/cm²)
Two rubber seals are provided
with inlet hose connectors.
These are used to prevent water
leakage.
Make sure the connection to tap
is sufciently tight.
Check rubber seals in inlet hose
connectors.
Screw the hose connector onto
water supply tap.
Hose
Connector
Rubber
seal
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
- Intensive
- Pre Wash
Page is loading ...
Page is loading ...
By Pressing the Option Button, all Option
functions may be selected.
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Close the door and press
Start/Pause button two times.
*Still, if is not released , call for
service.
Page is loading ...
This product does not contain any of the hazardous substances as specied in rule 13(1) and (2) of the e-waste
( Management and Handling ) Rules, 2011.
4.
5.
यह उपाद ई-अपिश (बंधन और हथालन) िनयम 2011 के अतगत 13(1) एवं (2) के तहत िनद खतरनाक पदाथ क आव यकता का
पालन करता ह ै
Page is loading ...
Page is loading ...
/