Robus R208PS-01 User manual

R208PS-01
Robus
Brand
Robus
Model
R208PS-01
Type
User manual

Robus R208PS-01 is a circular downlight with a GU10 lamp holder, suitable for mounting on normally flammable surfaces. It has an IP20 rating, making it suitable for indoor use. The downlight has an overall diameter of 105mm, a depth of 90mm, and requires a cutout of 85mm. It can accommodate a GU10 lamp with a maximum wattage of 50W. The downlight is easy to install, with spring-loaded clips for quick and secure mounting. It is also dimmable, allowing you to adjust the brightness to your preference.

Robus R208PS-01 is a circular downlight with a GU10 lamp holder, suitable for mounting on normally flammable surfaces. It has an IP20 rating, making it suitable for indoor use. The downlight has an overall diameter of 105mm, a depth of 90mm, and requires a cutout of 85mm. It can accommodate a GU10 lamp with a maximum wattage of 50W. The downlight is easy to install, with spring-loaded clips for quick and secure mounting. It is also dimmable, allowing you to adjust the brightness to your preference.

Model No.
Supply Voltage:
Lamp Type:
Ta Range:
IP Rating:
Safety Class:
Overall Diameter:
Depth:
Cutout:
Weight:
Warranty:
Suitable for mounting on normally flammable surface
Complies with EN60598 (BS4533)
R201PS
220-240V~50/60Hz
GU10 Max.50W
-20°C < ta < 40°C
IP20
Class II
80mm
90mm
60mm
0.1Kg
2 year
R208PS
220-240V~50/60Hz
GU10 Max.50W
-20°C < ta < 40°C
IP20
Class II
105mm
90mm
85mm
0.19Kg
2 year
1 Ensure mains supply is switched off
2 Mark ceiling with appropriate cut-out size
3 Before cutting, ensure that the hole does not impinge on
joists, pipe work, cables or other building services
4 Ensure there is at least 50mm of free space around and
25mm above the luminaire. Do not cover the luminaire
with thermal insulation
5 Connect supply cables Live and Neutral to fitting
terminals (polarity is unimportant). Do Not Earth
6 Fit springs and offer luminaire up to cut-out with the
longer leg of each spring being held vertically. The
luminaire is retained in position by the spring tension
between the short and the long leg of each spring against
the ceiling
7 Lamp installation and replacement:
! Ensure mains supply is off. ! When operating the
luminaire is too hot to touch. Switch off and allow to cool
before undertaking any maintenance work. Remove clip
to release the lamp.
GU10 PRESSED STEEL
CIRCULAR DOWNLIGHT
R201PS-01/03/13, R208PS-01/03/13
a: NA
b:50mm
c: NA
b 25mm
ab
d
c
Lamp
enclosure Control
gear
Luminaires and transformer not suitable for
covering with thermally insulating material
Suitable for mounting on normally flammable surface
Minimum distance from illuminated object is 0.5 metre
0.5m
INSTRUCTION MANUAL
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
! Electrical products can cause death or injury, or damage to property. If in any doubt about the installation or
use of this product, consult a competent electrician
Note:
Product technical information and specification may change over time without prior notification
For the latest technical information please visit our web site WWW. ledgrouprobus.com or robusdirect.com
Specifications Installation
Issue 1 080115
The Installation must be carried out by an electrician
LED Group
Western Retail Park Tel: +353 1 7099000
Nangor Road Fax: +353 1 7099060
Dublin 12 Email: [email protected]
Ireland Website: www.led.ie
ISO 9001:2008
Q UAL ITY ASS U RE D CO M PANY
1. Please note the requirement to dispose of Waste Electrical & Electronic Equipment separately from household waste (WEEE marked with
crossed out wheelie bin symbol).
2. Please consider your role in contributing to re-use and recycling by returning this product at end of life to a collection centre for waste electrical
equipment or a Civic Amenity site, or to a retail outlet from which you are purchasing a replacement.
3. This equipment may contain substances that are hazardous to health and the environment if disposed of carelessly. It is important that it is
separated from normal household waste and recycled in the WEEE chain
4. The “crossed out wheelie bin symbol” on a product indicates this equipment must not be disposed of in normal household waste, but should be
disposed of according to local WEEE regulations
Information for the Product user:
1
R201PS
R201PS R201PS
65mm dia.
85mm dia.
R208PS
R208PS R208PS
dia.
dia.
D
D
R201PS 80mm
105mm 90mm
90mm
R208PS
Dia.
L
N
200
1 2
3 4
5 6
Installation diagram
The Installation must be carried out by an electrician
LED Group
Western Retail Park Tel: +353 1 7099000
Nangor Road Fax: +353 1 7099060
Dublin 12 Email: [email protected]
Ireland Website: www.led.ie
ISO 9001:2008
Q UAL ITY ASS U RE D CO M PANY
2
  • Page 1 1
  • Page 2 2

Robus R208PS-01 User manual

R208PS-01
Robus
Brand
Robus
Model
R208PS-01
Type
User manual

Robus R208PS-01 is a circular downlight with a GU10 lamp holder, suitable for mounting on normally flammable surfaces. It has an IP20 rating, making it suitable for indoor use. The downlight has an overall diameter of 105mm, a depth of 90mm, and requires a cutout of 85mm. It can accommodate a GU10 lamp with a maximum wattage of 50W. The downlight is easy to install, with spring-loaded clips for quick and secure mounting. It is also dimmable, allowing you to adjust the brightness to your preference.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents