DEATSCH DW300 Installation guide

Hello, I'm your chat assistant. I have reviewed the Fuel Pump DW200/300 DW201S/301S Installation Guide, which outlines the necessary steps for installing the fuel pump in 03-8 Nissan 350Z and Infiniti G35 vehicles. The document includes a parts list and detailed instructions. I'm ready to answer your questions about the installation process or the features of the included parts.
What vehicles is this guide for?

What is included in the parts list?

What should be used instead of the instructions present in this guide?

DeatschWerks

03-8 Nissan 350Z/Infiniti G35 DW200/300 Fuel Pump Installation Guide

9-201S/301S-1005

03-8 Nissan 350Z/Infiniti G35 DW200/300

Fuel Pump Installation Guide

Parts List:

• DW201S/301S

• Orings (x3)

• Fuel Sock

• Super Lube

DeatschWerks

03-8 Nissan 350Z/Infiniti G35 DW200/300 Fuel Pump Installation Guide

03-8 Nissan 350Z/Infiniti G35 DW200/300 Fuel Pump Install

PLEASE READ – this guide is intended to aid in the installation of our products. It is recommended that

factory manuals or instructions are followed to remove the fuel pump assembly from the vehicle. Some

instructions in this guide are generic. The factory manual should supersede any contradiction.

Below is a picture of suggested tools that will make the installation process easier.

DeatschWerks

03-8 Nissan 350Z/Infiniti G35 DW200/300 Fuel Pump Installation Guide

1 – remove the fuel temperature sensor and disconnect the electrical connectors from the pump and level

sensor

2 – lift the slide over the tab and pull the bucket away from the center section

3 – pry the pump retainer off the center section and pull the pump out

DeatschWerks

03-8 Nissan 350Z/Infiniti G35 DW200/300 Fuel Pump Installation Guide

4 – prep the DW200/300 using all 3 orings on the pump outlet

5 – install the DW200/300 into the center section. The OE pump isolator/grommet will NOT be used

DeatschWerks

03-8 Nissan 350Z/Infiniti G35 DW200/300 Fuel Pump Installation Guide

6 – plug the connectors back in and replace the fuel temperature sensor

7 – reinstall the assembly into the fuel tank and attach a length of hose to the outlet of the pump

assembly allowing it to drain into a fuel safe container and prime the fuel pump assembly

8 – cycle the key to the on position as many times as required to prime the pump assembly and evacuate

the air introduced during the pump installation process

9 – attach supply line to the outlet of the pump assembly