Programme interruption
Opening the door when a programme is running is not recommended especially during the main wash and final hot
rinse phases. However, if the door is opened while a programme is running (for example, to add dishes) the machine
stops automatically.
Close the door, without pressing any buttons. The cycle will start from where it left off.
Changing a running programme
Proceed as follows to change or cancel a running program:
• Open the door.
• Hold down the current programme button (with the indicator light on) for at least 5 seconds. The programme
indicator lights (except for the "RAPID" programme indicator light) will flash.
• The running programme will be cancelled and the indicator light for the "recommended" programme or the
indicator light for the programme that was used at least 3 times consecutively will start to flash.
• At this point a new programme can be set.
Programme end
At the end of the programme, the indicator light for the "recommended" programme or the indicator light for the
programme that was used at least 3 times consecutively will start to blink.
Dishes can now be removed and the dishwasher turned off by pressing the "ON/OFF" button or dishes can be loaded
for new cycle.
Option Button
“Half load” button
By using this option, it is possible to wash a smaller quantity of crockery: you should load only the upper basket for
dishes and place cutlery in the tray in the bottom basket.
This reduces the water and energy consumption and requires a smaller quantity of detergent.