2. SMANIA
  3. LED Car Foot
LED Car Foot

SMANIA LED Car Foot Operating instructions

  • Hello! I've reviewed the instructions for the Car Foot Light DISCODOTS. This document describes the installation and functionality of the car foot lights, including how to connect the light bars, use the remote control, and the various lighting modes available. I'm ready to answer your questions about this product.
  • What is included in the package?
    How are the lights powered?
    How do I control the lights?
INSTRUCTIONS
LED CAR FOOT LIGHT
DISCODOTS
PACKAGE CONTENTS
• 4 light bars
• Remote
• Adapter
• USB power cable
• 4 connecting cables
• 8 Velcro strips
• Instructions
TECHNICAL SPECIFICATIONS
• Input voltage: 5 V
• Remote power supply: 1 CR2025 battery
• Size: 13.1 × 2.9 × 0.8 cm
• Power: 3.2 W
• Casing material: plastic
• Weight: 300 g
SETUP
Light bars are installed underneath the dashboard on
both the drivers and passenger side as well as
underneath the seats to light up the back row of your
car (see the picture below).
• Take 4 Velcro strips and paste them on the
back side of 4 light bars.
• Use 4 connecting cables to connect light bars
with the adapter.
• Take the other 4 Velcro strips and paste
them on the areas in your car where you
want to install the light bars (underneath the
dashboard and seats).
• Attach the connected light bars on Velcro
strips.
• Hide the cables inside the seat pads so that
they don’t disturb you during driving.
• Finally, connect the adapter with the USB
port in your car using the USB power cable.
• The DiscoDots lights are now ready to use.
• Use the included remote to control the
lights.
For a pictorial representation of the installation, see
the images below.
REMOTE CONTROL
1. ON/OFF button
2. Reset
3. Red
4. Blue
5. Green
6. Yellow
7. Purple
8. Ice blue
9. White
10. 7-color cycle mode
11. Breathing mode
12. Sound-activated mode 1
13. Sound-activated mode 2
14. Sensitivity enhancement
15. Sensitivity reduction
NOTE: Before you use the remote for the first time,
pull out the plastic battery protector.
WARNINGS
• Do not look directly into the lights. This
might cause eye damage or even blindness.
• This product is intended for indoor use. Do
not install the lights on the outside of your
car.
• Store in a dry and dark place. The device can
be damaged by water or moisture.
• Keep away from open flames and heat.
• This is not a toy. Keep away from children.
• Do not disassemble or modify in any way.
• Only use the product for its intended
purpose.
• Before each use, check if the light has any
visible damage or defects. Do not use it if
damaged.
• Only use the included adapter and cables.
WARRANTY
The warranty is valid for 24 months. You can claim it
from DFVU d.o.o., Liparjeva 6a, 1234 Mengeš,
Slovenia, for a replacement product or a refund.
Send us your order number and purchase date in the
email, which is available by clicking on our logo in the
bottom right corner. The product has a lifetime of 24
months from the date of collection.
WEEE disposal and recycling symbol.
The WEEE symbol is attached to the
product in compliance with the EU
directive 2012/19/EU on Waste
Electrical and Electronic Equipment
(WEEE). It is intended to deter the
improper disposal of this product and
to promote reuse and recycling.
/