PLUGITIN
FOREIGNOBJECTDETECTION
Remove phone rings or wallets
mounted on device as they will
interfere with charging
LEDLIGHTSTATES
LIGHTSENSOR
will automatically
enter LED into
Night Mode when
the room is dark
or the sensor is
covered
Plug USB cable into an 10W or
higher power supply.
NOTE:
Not recommended for use with
a laptop (Some laptops may
have enough power to deliver
a slow charge to one product)
This product contains magnets and components that generate strong electromagnetic fields. Keep your
Quad Lock product a safe distance away from any sensitive or implanted medical devices. Consult with
your medical practitioner or device manufacturer before use, or if you suspect the product is interfering
with your device.
Annex Products Pty Ltd, Australia, declares that the products “Wireless Charging Pad”, complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
NOTE: The “Wireless Charging Pad” has been tested and found to comply with the limits for a Class B device, pursuant to Part 15 of
the FCC Rules and has been assigned FCC ID: 2AOU9-WCP. These limits are designed to provide reasonable protection against harmful
interference . This equipm ent generates, uses , and can radi ate radio freq uency energy an d, if not inst alled and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipm ent off and on, the user is encoura ged to try to correct th e interference by one or more of th e following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
•
Consult the dealer or an experienced technician for help.
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with a minimum distance of 20cm between the radiator and your body. Use only supplied antenna.
CAUTION: Any changes or modifications in construction of these devices which are not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device was tested for operation s. To comply with RF ex posure requirements, a min imum separation dista nce of 20cm must
be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar
accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these
requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved
antenna.
This device in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. All essential radio test
suites have been carried out. This restriction will be applied to all Member States of European Union.
1.
The device complies with RF specifications when the device used at 20cm form your body
DeclarationofConformity
Hereby, Annex Products Pty Ltd declares that the product “Wireless C h a r g i n g P a d ” is i n c o m p l ia n c e w i t h Di r ec t iv e s 2 0 14 / 53 /E U & 2011/65/
E U . T h e f u l l t e x t o f t h e E U d e c l a r a t i o n o f c o n f o r m i t y i s a v a i l a b l e a t t h e f o l l o w i n g i n t e r n e t a d d r e s s : h t t p s : / / w w w . q u a d l o c k . c o m . au/compliance
This device was tested for operations. To comply with RF exposure requirements, a minimum separation distance of 20cm must be
maintained between the user’s body and the charger, including the antenna. Third-party belt-clips, holsters, and similar accessories
used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may
not co mp ly wi th RF exposure requirements an d s ho ul d b e avoided. Us e on ly th e s up pl ie d o r a n approved an tenna .
The device is in compliance with the essential requirements and other relevant provisions of the UK Radio Equipment Regulations SI
2017:1206 (as amended).
DAYMODE
CHARGERBASE
NIGHTMODE
CHARGERBASE
NO
CHARGING
CHARGING
LIGHT GOES OFF AFTER 3 SECS
ERROR
/
FOREIGN
OBJECT
DETECTION
LIGHT GOES OFF AFTER 3 SECS