Campfire Audio 2AS58-01 User manual

Brand: Campfire Audio

Model: 2AS58-01

Type: User manual

Campfire Audio 2AS58-01 offers a seamless wireless experience with Bluetooth connectivity. Enjoy crystal-clear audio and calls with its high-quality sound drivers. Activate voice assistant, play/pause music, adjust volume, and answer/reject calls with simple touch controls. The earbuds automatically reconnect to your device when in range. With its long battery life, you can listen to your favorite tunes for hours on end. Experience the freedom of wireless audio with Campfire Audio 2AS58-01.

Campfire Audio ORBIT

Regulations and Operations Manual

Regulatory Compliance Information

EU / UK Compliance

English

Campfire Audio hereby declares that this wireless device is in compliance with Directive

2014/53/EU and Radio Equipment Regulations 2017. A copy of the Declaration of Conformity

is available at campfireaudio.com/compliance.

FCC Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be

used in portable exposure condition without restriction.

FCC ID: 2AS58-01

ISED Statement

‐ English

This device complies with Industry Canada license‐exempt RSS standard(s). Operation is

subject to the following two conditions: (1) This device may not cause interference, and (2) This

device must accept any interference, including interference that may cause undesired operation

of the device. The digital apparatus complies with Canadian CAN ICES‐3 (B)/NMB‐3(B).

This device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102

and compliance with RSS 102 RF exposure, users can obtain Canadian information on RF

exposure and compliance.

This equipment complies with Canada radiation exposure limits set forth for an uncontrolled

environment.

RF Exposure Statement

The device has been evaluated to meet general RF exposure requirement. The device can be

used installed and operated with minimum distance 0mm between the radiator and your body.

‐ French: Le présentappareilestconforme aux CNR d'Industrie Canada applicables aux

appareils radio exempts de licence. L'exploitationestautorisée aux deux conditions suivantes: (1)

l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareildoit accepter tout

brouillageradioélectriquesubi, mêmesi le brouillageest susceptible d'encompromettre le

fonctionnement. L'appareil numérique est conforme à CAN CAN ICES-3 (B) / NMB-3 (B).

cet appareil est conforme à l'exemption des limites d'évaluation courante dans la section 2.5 du

cnr - 102 et conformité avec rss 102 de l'exposition aux rf, les utilisateurs peuvent obtenir des

données canadiennes sur l'exposition aux champs rf et la conformité.

Cet équipement est conforme aux limites d'exposition aux rayonnements du Canada établies

pour un environnement non contrôlé.

L'appareil a été évalué pour répondre aux exigences générales d'exposition aux RF.Cet

équipement doit être installé et utilisé avec une distance minimale de 0 mm entre le radiateur et

votre corps.

IC：24976-01

Operations: Orbit UI

Function

Operation

Use Function Results

First-time

Bluetooth Pairing

Put the left and right earphones into the

charging box to charge, open the cap of the

charging box, and press and hold the reset

button for 3 seconds to enter the Bluetooth

pairing mode. Then open phone settings >

Bluetooth devices > refresh devices and

select “CAMPFIRE”

Left and right earphone

lights flash alternately,

indicator lights will go out

after successful pairing.

Pairing mode: all 4 LEDs

will flash 3 times

simultaneously.

1. Open the upper cover of the charging box

and auto turn on the device and enter the

automatic connection.

2. Press and hold the left and right earphones

for 5 sec to shut down w/ earphones outside

of charging box

Power on prompt tone:

“ON”

OFF

1. Place earphones into charging box and

close cap to automatically turn off

2. Long press the left and right earphones for

5s to shut down

3. Earphones will auto shut down after 10m

without pairing

4. Earphones will turn off from low battery

Power off prompt tone:

“OFF”

Rest

Long press the charging box for 10s

Auto re-connect

1. Open the charging box cover

2. Earphones will connect to last connected

device

Long-distance

connection and

automatic return

connection

After disconnecting beyond the use distance

range, the headset will auto-reconnect when

back within range unless 10m has passed

and earphones have turned off.

Bluetooth

Disconnected

1. Auto disconnect when out of range

2. Manual disconnect/turn-off

3. Mobile phone is disconnected or has

Bluetooth turned off

Play and Pause

Music

In the playback state, tap once on either

earphone to play or pause music.

Previous song

Double-tap the left earphone

Next song

Double-tap the right earphone

Volume +

Long press the Right earphone, hold to

continuously increase volume

Volume -

Long press the Left earphone, hold to

continuously increase volume

Voice Assistant

activation

Triple tap Left or Right earphone to wake up

voice assistant (siri)

Answer Call

Single-tap either earphone during incoming

call

Hang up

During call, single-tap either earphonel

Reject the call

Double-tap either earphone during incoming

call

DUT mode

When the left and right earphones are paired

double-tap the MFB button

Charging box

battery indicator

Open the cover of the charging box or click

the button of the charging box to display

battery level

One light - 25%

Two light - 50%

Three light - 75%

Four light - 100%

IPhone battery

display

Earphone battery level and bluetooth

connection will be displayed on Iphone

IPhone Volume

sync

Volume of the earphones are synchronized

with the volume of the mobile phone

Charging box

battery indicator

Open cover of charging box and press button

to display the battery level of the charging box

Earphone charging

Place earphones in charging box and close

cover. Device will disconnect after 3 seconds.

One earphone can be placed in the charging

box without affecting the use of the single

earphone.

Bluetooth pairing

Long press the charging box for 3s

Indicator lights will flash in

marquee pattern

reset

Long press the charging box for 10s to restore

factory settings

Campfire Audio 2AS58-01 User manual

Brand: Campfire Audio

Model: 2AS58-01

Type: User manual

Download PDF

report

in other languages

français: Campfire Audio 2AS58-01 Manuel utilisateur

Campfire Audio 2AS58-01 User manual

Campfire Audio 2AS58-01 User manual

in other languages

Other documents